TM 2017-25 Door and Gate Surfaces Effective Date: April 1, 2017 2012 TAS Reference: 404.2.10 404.2.10 requires door and gate surfaces within 10 inches (255mm) of the finish floor...
Search Results "Clear Floor Space"
Filters
Commonly Searched Documents
-
Technical Memorandum TM 2017-25 Door and Gate Surfaces
-
Allegion Von Duprin 94/95 Series INPACT Recessed Exit Device
(Optional LBR is available, with no need for floor strike.)...
-
H. Your Obligation to Provide Services and Equipment
The on-board wheelchair must be designed to be compatible with the maneuvering space, aisle width, and seat height of the aircraft on which it is to be used, and to easily be pushed, pulled...
-
ALTERATION
INTERPRETATION A change in occupancy or use is a change in the major activity for which the room, space, unit, or facility is intended....
-
APPENDIX IV: Recent Department of Transportation Enforcement Orders Related to the Air Carrier Access Act
6943 “Medically-prescribed marijuana” 5/27/04 2004-5-25 OST-2003-4808 Failure to provide a priority space...
-
704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (865 mm) minimum above the finish floor....
-
Detectable Warnings
This revision does not substantively change the requirements for the coordination of platforms and vehicle floors. 28 36 CFR part 1192...
-
Substantive changes made to requirements for elevators
the proposed rule) modification of specifications for audible hall signals (407.2.2.3) and audible car position indicators (407.4.8.2) revision of the height of tactile floor...
-
1007.7.4 Separation
The fire-resistance-rated construction shall extend vertically from the ground to a point 10 feet (3048 mm) above the floor level of the area for assisted rescue or to the roof line, whichever...
-
Is it OK to examine a patient who uses a wheelchair in the wheelchair, because the patient cannot get onto the exam table independently?
A good option is to have a table that adjusts down to the level of a wheelchair, approximately 17‒19 inches from the floor....
-
M301.2.1 Adjustability (Section-by-Section Analysis)
four additional transfer heights located between the low and high transfer heights, separated by one inch minimum increments; and (4) the transfer surface height will be measured from the floor...
-
608.3 Grab Bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor....
-
QUESTION: WHAT LIMITATIONS CAN A PVO IMPOSE WITH RESPECT
TO CARRYING A SERVICE ANIMAL?
* For example, a PVO could impose a legitimate safety requirement that a service dog not be permitted to enter a sauna or steam room, sit on any surface other than the floor, or join...
-
704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (865 mm) minimum above the finish floor....
-
610.3 Shower Compartment Seats
The top of the seat shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the bathroom finish floor. Seats shall comply with 610.3.1 or 610.3.2....
-
307.2 Protrusion Limits
Objects with leading edges more than 27 inches (685 mm) and not more than 80 inches (2030 mm) above the finish floor or ground shall protrude 4 inches (100 mm) maximum horizontally into...
-
704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (865 mm) minimum above the finish floor....
-
Permanently Installed Systems
Vertical wheelchair lifts are differentiated from elevators because they are limited in the height of their vertical lift, are not enclosed, and do not go through a floor level....
-
Door and Gate Surfaces [§404.2.10]
These requirements do not apply to: Sliding doors Doors and gates that do not extend to within 10” of the finish floor or ground Existing doors or gates with kick...
-
Error/Omission: The shape of the door hardware requires tight grasping, pinching, and twisting of the wrist to use.
Hardware required for accessible door passage shall be mounted no higher than 48 in (1220 mm) above finished floor....
-
11B-307.2 Protrusion limits
Objects with leading edges more than 27 inches (686 mm) and not more than 80 inches (2032 mm) above the finish floor or ground shall protrude 4 inches (102 mm) maximum horizontally into...
-
11B-307.2 Protrusion limits
Objects with leading edges more than 27 inches (686 mm) and not more than 80 inches (2032 mm) above the finish floor or ground shall protrude 4 inches (102 mm) maximum horizontally into...
-
Society for the Blind
While the original intent of the founders of Society for the Blind was to provide a congregating space for people in the Sacramento area who were blind or low vision, today’s vision includes...
-
Neurofibromatosis Network
The network is a dynamic and growing open space for shared resources, development of new tools, and creation of innovative programs. ...
