Landings shall comply with 405.7. Advisory 405.7 Landings....
Search Results "Comply With"
-
405.7 Landings
-
Alterations to Areas Containing a Primary Function
Requirements specific to altered residential dwelling units in section 233.3 effectively substitute for this provision by ensuring an accessible route to those dwelling units required to comply...
-
803.1 General
Dressing, fitting, and locker rooms shall comply with 803. Advisory 803.1 General....
-
B. Chapter 2: Scoping (Section-by-Section Analysis)
Access Board did not receive any comments regarding Chapter 2 as written; however, several commenters expressed concern regarding the ability of certain types of diagnostic equipment to comply...
-
304.3.2 T-Shaped Space
The space shall be permitted to include knee and toe clearance complying with 306 only at the end of either the base or one arm. Figure 304.3.2 T-Shaped Turning Space...
-
904.4.1 Parallel Approach
A clear floor or ground space complying with 305 shall be positioned for a parallel approach adjacent to the 36 inch (915 mm) minimum length of counter....
-
502.6 Identification
Parking space identification signs shall include the International Symbol of Accessibility complying with 703.7.2.1....
-
Animal Containment Areas
These areas must comply with all ADAAG requirements, except the requirements that surfaces be stable, firm, and slip resistant and the restrictions on changes in level since some surfaces...
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
1008.2.1 Ground Level and Elevated Play Components
Transfer systems complying with 1008.3 shall be permitted to connect elevated play components except where 20 or more elevated play components are provided no more than 25 percent of the...
-
402.2 Components
All components of an accessible route shall comply with the applicable requirements of Chapter 4. Advisory 402.2 Components....
-
Roll-in Access [1014.2.2]
To provide roll-in access into a camp shelter, a level or sloped entry route that complies with the technical requirements for an ORAR or trail, as applicable, must be provided along the...
-
R309.3 Perpendicular or Angled Parking Spaces
The access aisle shall comply with R302.7 and shall be marked so as to discourage parking in the access aisle. Two parking spaces are permitted to share a common access aisle....
-
E203.1 General
Agencies shall ensure that all functionality of ICT is accessible to and usable by individuals with disabilities, either directly or by supporting the use of assistive technology, and shall comply...
-
§ 36.606(d)
certification of equivalency was effective shall be considered rebuttable evidence of compliance with the Standards then in effect as to those elements of buildings and facilities that comply...
-
1(5) Accessible route
An accessible route that complies with ANS14.3 would meet section 100.205(a)....
-
Subtitle B: Public Transportation
Public transportation authorities must comply with requirements for accessibility in newly purchased vehicles, make good faith efforts to purchase or lease accessible used buses, remanufacture...
-
§8.32(a)
Effective as of July 11, 1988, design, construction, or alteration of buildings in conformance with sections 3-8 of the Uniform Federal Accessibility Standards (UFAS) shall be deemed to comply...
-
Who has to follow part 382?
The following organizations and individuals must comply with part 382: (1) air carriers and their employees (e.g., ticket and gate agents, flight attendants, baggage handlers, pilots, etc...
-
11. Appendix D to Part 37 is amended by
Under Section 37.93 remove the period at the end of last sentence in the third paragraph and replace with it comma, and add the following language: “except where doing is necessary to comply...
-
Raised character and Braille exit signs
Raised character and Braille exit signs shall comply with Chapter 11A, Section 1143A or Chapter 11B, Sections 11B-703.1, 11B-703.2, 11B-703.3 and 11B-703.5....
-
11B-206.8 Security barriers
Exception: Where security barriers incorporate elements that cannot comply with these requirements such as certain metal detectors, fluoroscopes, or other similar devices, the accessible...
-
11B-602.9 Pedestrian protection
The protected area within which a drinking fountain is located shall be 32 inches (813 mm) wide minimum and 18 inches (457 mm) deep minimum, and shall comply with Section 11B-305.7....