The Access Board is statutorily responsible for developing accessibility guidelines for telecommunications equipment and customer premises equipment (CPE)....
Search Results "Accessibility Standard"
Commonly Searched Documents
-
B. Regulatory Flexibility Act
-
c) RecPark Program
MOD works closely with RecPark staff and provides guidance on accessibility issues, such as the priorities selected for the 2008 Bond and the accessibility standards to apply....
-
11B-810.5.3 Platform and vehicle floor coordination
Access Board's Note to Reader: The Department of Transportation's ADA Standards note permitted alternatives where compliance is not operationally or structurally feasible in light rail...
-
Height: ADA Standard Section 1005.2.1
1003.2.12.2 of the International Building Code (2000 edition) or sections 1012.2 and 1012.3 of the International Building Code (2003 edition) (incorporated by reference, see “Referenced Standards...
-
a. The employer's judgment
the quality or quantity of work that must be performed by a person holding a job, or be required to set lower standards for the job....
-
Restrooms Main Lobby
See Standards § 4.13.6. l....
-
7. APPLICABILITY
These new DoD Standards are effective immediately....
-
Minimum Rear Wall Required.
It appears that this comment references the 2010 ADA Standards for Accessible Design for minimum bench length (42") but uses the CA - 2013 minimum bench length (48") to develop the minimum...
- Midmark Ritter 223 Barrier-Free® Power Examination Table
-
5.2.2.1 Transfer Surface Width Recommendations for M302
recommends 21 inches for the minimum width of the transfer surface of examination chairs and other equipment primarily used by patients in a seated position as described in its proposed standard...
-
24.1 Q. What types of grab bars should the reinforcement be designed to accommodate and what types may be used if the builder elects to install grab bars in some units at the time of construction?
In determining what is an appropriate grab bar, builders are encouraged to look to the 1986 ANSI A117.1 standard, the standard cited in the Fair Housing Act....
-
§ 36.304(d)(2)(iii)
., elements for which there are neither technical nor scoping specifications in the 1991 Standards), and therefore those elements must be modified to the extent readily achievable to comply...
-
Alterations and Additions
This guide provides an introduction to the scoping requirements that form the basis for the Department of Justice’s 2010 ADA Standards and the Department of Transportation's ADA Standards...
- Oasis Barrier-Free Universal Split-Level VersaCooler II P8ACSL
-
The Department’s Rulemaking History
Board’s revisions once the Department adopts them as revised standards; and (2) to request background information that would assist the Department in preparing a regulatory analysis under...
-
The Department's Rulemaking History
Board's revisions once the Department adopts them as revised standards; and (2) to request background information that would assist the Department in preparing a regulatory analysis under...
- Inpro ENDURANT® Shower Receptors
-
E202.7 Best Meets
Where ICT conforming to one or more requirements in the Revised 508 Standards is not commercially available, the agency shall procure the ICT that best meets the Revised 508 Standards consistent...
- Inclusion Solutions BigBell™ Alert System
- Yale Affinity® Smart Card Locks
-
11B-904.4.1 Parallel approach
[2010 ADA Standards] 904.4.1 Parallel Approach....
-
11B-605.4 Flush controls
[2010 ADA Standards] 605.4 Flush Controls. Flush controls shall be hand operated or automatic. Hand operated flush controls shall comply with 309....
-
11B-903.3 Size
[2010 ADA Standards] 903.3 Size. Benches shall have seats that are 42 inches (1065 mm) long minimum and 20 inches (510 mm) deep minimum and 24 inches (610 mm) deep maximum....
-
11B-404.2.5 Thresholds
[2010 ADA Standards] EXCEPTION: Existing or altered thresholds ¾ inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required...