Floor or ground surfaces of a clear floor or ground space shall comply with 302. Changes in level are not permitted....
Search Results "Parking Surface"
Commonly Searched Documents
-
305.2 Floor or Ground Surfaces
-
609.5 Surface Hazards
609.5 Surface Hazards. Grab bars and any wall or other surfaces adjacent to grab bars shall be free of sharp or abrasive elements and shall have rounded edges....
-
505.6 Gripping Surface
Where handrails are provided along walking surfaces with slopes not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along their entire length...
-
Handrail Gripping Surfaces: ADA Standard Section 1008.2.5.3.1
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 0.95 inch (24 mm) minimum and 1.55 inches (39 mm) maximum....
- Seton California State Signs - Parking Only with ISA and Minimum Fine
-
A4.6 Parking and Passenger Loading Zones
[See subsections ...]
-
4.6 Parking and Passenger Loading Zones
[See subsections ...]
-
A4.6 PARKING AND PASSENGER LOADING ZONES
[See subsections ...]
-
4.6 PARKING AND PASSENGER LOADING ZONES
[See subsections ...]
-
505.6 Gripping Surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
209.5 Mechanical Access Parking Garages
209.5 Mechanical Access Parking Garages....
-
a. Transfer Surface Adjustability
The MDE NPRM proposed that the same transfer surface height range of 17 inches minimum to 19 inches maximum be applied to both diagnostic equipment used in the supine, prone, or side-lying...
-
B. Access Aisles
Does each accessible parking space have or share an adjacent access aisle to allow persons who use wheelchairs, walkers or other mobility aids to transfer from their car/van?...
-
Has there been consideration for electric vehicles being parked in valet mode that could share EVSE and meet the equivalent EVSE option? This could reduce the cost of construction and major electrical upgrades.
RESPONSE: Electric vehicles may be parked by a valet just as any other car....
-
Door and Gate Surfaces [§404.2.10]
Door and Gate Surfaces [§404.2.10] The bottom surface of doors and gates on the push side must be smooth to a height of at least 10”....
-
Technical Bulletin: Ground and Floor Surfaces
UNITED STATES ACCESS BOARD A FEDERAL AGENCY COMMITTED TO ACCESSIBLE DESIGN Technical Bulletin: Ground and Floor Surfaces...
-
11B-502.6.2 Minimum fine
Additional language or an additional sign below the International Symbol of Accessibility shall state “Minimum Fine $250.”
-
A9. Accessible Route
Does each access aisle connect to an accessible route from the parking area to the accessible building entrance? [ADA Stds 4.6.2] Yes _____ No _____...
-
11B-404.2.4.4 Floor or ground surface
Floor or ground surface within required maneuvering clearances shall comply with Section 11B-302....
-
11B-902.4 Dining surfaces and work surfaces for children’s use
Accessible dining surfaces and work surfaces for children’s use shall comply with Section 11B-902.4....
-
11B-902.4 Dining surfaces and work surfaces for children’s use
Accessible dining surfaces and work surfaces for children’s use shall comply with Section 11B-902.4....
-
11B-902.4 Dining surfaces and work surfaces for children’s use
Accessible dining surfaces and work surfaces for children’s use shall comply with Section 11B-902.4....
-
Firmness, Stability, and Slip Resistance [§302.1]
Firmness, Stability, and Slip Resistance [§302.1] Accessible floor and ground surfaces must be stable, firm, and slip resistant....
-
IV. Discussion of Findings and Implications
of surface maintenance to assure accessibility and safety for use by children on a daily basis. ...