11 [§ 4.7.6] A built-up curb ramp typically consists of asphalt or concrete that is poured and shaped into a ramp that runs at a 90-degree angle away from an intact curb down to the roadway...
Search Results "Ramp Slope"
Commonly Searched Documents
-
11 [§ 4.7.6]
-
1018.7.1 Maximum Running Slope and Segment Length
The running slope of any segment of a beach access route shall not be steeper than 1:10 (10%). ...
-
1018.7.1 Maximum Running Slope and Segment Length
The running slope of any segment of a beach access route shall not be steeper than 1:10 (10%)....
-
B7. Curb Ramp Width
Is the width of the curb ramp surface at least 36 inches? [ADA Stds 4.7.3] Yes _____ No _____...
-
Diagonal Curb Ramps
Section 406.6 provides specifications for diagonal (or corner type) curb ramps. These curb ramps must have a 48 inch minimum clear space at the bottom....
-
Re: 405 Ramps
A ramp with a direction change requires a 60" x 60" minimum intermediate landing, which isn't just a turning space but also a place for stopping to allow for a turn....
-
11B-406.5.5 Wet conditions
Curb ramps and blended transitions shall comply with Section 11B-405.10....
-
11B-406.5.3 Landings
The slope of the landing in all directions shall be 1:48 maximum. Exception: Parallel curb ramps shall not be required to comply with Section 11B-406.5.3....
- Figure 405.9.1 Extended Floor or Ground Surface Edge Protection – Drawing from the U.S. Access Board
-
11B-406.5.3 Landings
The slope of the landing in all directions shall be 1:48 maximum. [Safe Harbor only applies to existing curb ramps in the vicinity of, and leading to, a primary entrance.]...
-
DSA Drawing 11B-406-1 Perpendicular Curb next to a Curb and Gutter (2016 CBC)
Requires the Premium User plan or above. (Login or upgrade your account!)
-
Clear Width: ADA Standard Section 405.5
Section 405.5 covers the current ADA Standards for the clear width requirements of ramps.
-
Submerged Depth
This depth is necessary for individuals using the sloped entry to become buoyant....
-
Appendix 2: Survey Forms: Curb Ramps
Describe each curb ramp’s location: Curb Ramp D: Curb Ramp A: Curb Ramp E: Curb Ramp B: Curb Ramp F: Curb Ramp C: Curb Ramp G:...
-
Why is a top landing required at curb ramps if side flares are provided?
A landing at least 36” long at the top of curb ramps provides room to approach or exit ramps and turn without encountering compound slopes of flared sides....
-
11B-809.10.6.2 Slope
The slope of the shower floor shall be 1/2 inch (12.7 mm) per foot maximum in any direction and shall slope to a drain....
-
11B-504.4 Tread surface
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted. Exception: Reserved....
-
11B-406.5.3 Landings
The slope of the landing in all directions shall be 1:48 maximum. [2010 ADA Standards] 406.4 Landings. Landings shall be provided at the tops of curb ramps....
- Designing Sidewalks and Trails for Access, Part II of II: Best Practices Design Guide
- SafePath VulcanLanding™ Rubber Transition Ramp
-
New Construction and Alterations
New Construction and Alterations DOJ’s title II ADA regulation provides that newly constructed or altered streets, roads, and highways must contain curb ramps or other sloped areas at...
- Designing Sidewalks and Trails for Access, Part I of II: Review of Existing Guidelines and Practices
-
Digital inclinometers (SmartTool®)
Digital inclinometers (SmartTool®), while slightly more expensive than standard levels, are easy to calibrate and use and can measure slopes in degrees, percent, and fractions per foot....
-
R304 Curb Ramps and Blended Transitions (Section-by-Section Analysis)
R304 Curb Ramps and Blended Transitions (Section-by-Section Analysis)...