Diagonal curb ramps provided at marked crossings shall provide the 48 inches (1220 mm) minimum clear space within the markings....
Search Results "Cross Slope"
2010 ADA Definition
Cross Slope: The slope that is perpendicular to the direction of travel (see running slope).
Filters
Commonly Searched Documents
-
406.6 Diagonal Curb Ramps
-
1(5) Accessible route
If the slope of the finished grade between covered multifamily dwellings and a public or common use facility (including parking) exceeds 8.33%, or where other physical barriers (natural...
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2 Description: This provision prescribes a cross-sectional profile of the transfer support...
-
3. New Construction vs. Alterations
curb ramps installed must meet the accessibility requirements of the ADA to the maximum extent feasible.10 Scoping requirements in the ADA Standards establish limitations for the running slope...
-
Swimming Pools: ADA Standard Section 242.2
Section 242.2 covers scoping requirements in the current ADA Standards for swimming pools.
-
1.1.8 Alternate measurement tools
Running slope should be measured along the same lines of measurements as given in Section 1.1.3....
-
Flange way gap
For rail projects, no flange way gap can be greater than 2.5" where passenger circulation paths cross tracks at grade (i.e. a street-level pedestrian crossing over streetcar tracks)....
-
TEST NO. 2 – SITE ANALYSIS TEST
Calculate the percentage of the total buildable area of the undisturbed site with a natural grade less than 10-percent slope....
-
TEST NO. 2 – SITE ANALYSIS TEST
route to all ground floor units under the following conditions: Calculate the percentage of the total buildable area of the undisturbed site with a natural grade less than 10-percent slope...
-
11B-242.2 Swimming pools
Accessible means of entry shall be swimming pool lifts complying with Section 11B-1009.2; sloped entries complying with Section 11B-1009.3; transfer walls complying with Section 11B-1009.4...
-
11B-404.2.4.4 Floor or ground surface
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted. Exceptions: Reserved....
-
2.4.1.2
A grade of up to 1:12 (8.33 percent) is permitted for up to 50 feet (15 m) of an ORAR. Resting intervals complying with section 2.3 shall be provided at distances of no more than 50...
-
5.4.6 Transfer Support Gripping Surface Cross Section for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
5.4.6 Transfer Support Gripping Surface Cross Section for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position....
-
DSA Drawing 11B-406-11 Diagonal Curb Ramp next to a Curb and Gutter (2016 CBC)
Requires the Premium User plan or above. (Login or upgrade your account!) -
DOJ/DOT Joint Technical Assistance on the Title II of the ADA Requirements to Provide Curb Ramps when Streets, Roads, or Highways are Altered through Resurfacing
An important part of this requirement is the obligation whenever streets, roadways, or highways are altered to provide curb ramps where street level pedestrian walkways cross curbs.2 This...
-
11.3 Q. The site analysis test calls for a calculation of the percentage of the buildable areas having slopes of less than 10 percent. What is the definition of buildable areas?
A. The buildable area is any area of the lot or site where a building can be located in compliance with applicable codes and zoning regulations.
-
305.2 Floor or Ground Surfaces
EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
305.2 Floor or Ground Surfaces
EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
11B-406.5.10 Diagonal curb ramps
Diagonal curb ramps with flared sides shall have a segment of curb 24 inches (610 mm) long minimum located on each side of the curb ramp and within the marked crossing....
-
Allen Face F-Meter® Rolling Floor Profiler
The F-Meter® is the finest floor profiling instrument ever made. Pulled manually across the floor, the F-Meter® can measure up to 2500 linear feet (5,000 point elevation readings!)...
-
The Dipstick® Floor Profiler Tool
Advantages The Dipstick Auto-Read Floor Profiler is a totally integrated data collection instrument that provides a fast and accurate method of measuring floors for flatness and...
-
11B-305.2 Floor or ground surfaces
Exception: Slopes not steeper than 1:48 shall be permitted...
-
11B-305.2 Floor or ground surfaces
Exception: Slopes not steeper than 1:48 shall be permitted....
-
305.2 Floor or Ground Surfaces
[ECTCR UFAS 4.2.4.3] EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
