(2) The railroad operator must submit a plan to FRA and/or FTA, describing its proposed means to meet the performance standard of paragraph (a) of this section at that station....
Search Results "ANSI/IEEE: American National Standards Institute/ Institute of Electrical and Electronics Engineers"
Filters
Commonly Searched Documents
-
§ 37.42(d)(2)
-
11B-407.2.1.1 Height
[2010 ADA Standards] EXCEPTION: Existing call buttons and existing keypads shall be permitted to be located at 54 inches (1370 mm) maximum above the finish floor, measured to the centerline...
-
11B-407.2.2.1 Visible and audible signals
[2010 ADA Standards] 2. In existing elevators, a signal indicating the direction of car travel shall not be required....
-
11B-407.4.6.2.1 Size and shape
[2010 ADA Standards] 407.4.6.2.1 Size. Buttons shall be ¾ inch (19 mm) minimum in their smallest dimension....
-
PRIVATE BUILDING OR FACILITY
[2010 ADA Standards 106.5] Private Building or Facility....
-
Section 37.3 Definitions
OPMDs are defined in Department of Justice ADA rules as “any mobility device powered by batteries, fuel, or other engines—whether or not designed primarily for use by individuals with mobility...
-
Ability Self-Assessment
(These cues will be absent, if the electricity goes off or alarms are blaring). Yes No Can you read the emergency signage in print or Braille?...
-
7.7 Evaluations, Discipline and Discharge
7.7 Evaluations, Discipline and Discharge An employer can hold employees with disabilities to the same standards of production/performance as other similarly situated employees...
-
4.1.1 Range of Examination Table and Chair Configurations
Dental chairs Optometric chairs Otolaryngology (ENT) chairs Phlebotomy chairs Podiatry chairs As noted in the NPRM for MDE accessibility standards...
-
What values are recommended for ground and floor surfaces along an accessible route?
Although this machine operates on a principle similar to that of the James machine, the use of a non-standard silastic sensor (instead of the leather required by the protocol for the UL...
-
Section 35.151(h) Medical Care Facilities (Section-by-Section Analysis)
The Department is proposing a new § 35.151(h) on medical care facilities, which now must comply with the applicable sections of the proposed standards. ...
-
QUESTION: WHERE THE REQUIREMENTS OF SECTION 37.42 APPLY, WHICH CARS OF A TRAIN DOES A RAILROAD OPERATOR HAVE TO MAKE AVAILABLE TO PASSENGERS WITH DISABILITIES?
ANSWER: The performance standard of section 37.42(a) requires that passengers with disabilities “must have access to all accessible cars available to passengers without disabilities...
-
Discussion
Visitors who are blind or have low vision want Braille and audio versions of publications that meet established standards....
-
3.2 Projects with Adjusted Construction Costs Above the Valuation Threshold
" • A finding of UNREASONABLE HARDSHIP may be made when the enforcing agency (DSA) finds that compliance with the building standard would make the specific work of the project affected...
-
Guestrooms with Roll-in Showers
Bathing facilities in these rooms must comply with the Standards....
-
11B-610.3 Shower compartment seats
A seat in a standard roll-in shower compartment shall be a folding type, shall be installed on the side wall adjacent to the controls, and shall extend from the back wall to a point within...
-
Senate Hearings and the Quest for Bipartisanship
.‡‡ He also became a national leader in disability issues, which included service as Director of the Epilepsy Foundation of America (EFA)....
-
11B-604.8.1.2 Doors
[2010 ADA Standards] 604.8.1.2 Doors....
-
Endorphin 325 Functional Wall Pulley
stabilizing exercises that improve balance and core strength Rotating arms adjust from ground level to 7 feet, 90º horizontally and 180º vertically ADA Compliant - Compliant with the Americans...
-
Safe Harbor is applied element by element in existing facilities
New, more detailed requirements for that element type were added in the 2010 ADA Standard. ...
-
1008.2.6 Ground Surfaces
Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....
-
11B-1008.2.6 Ground surfaces
Ground surfaces must be inspected and maintained regularly to ensure continued compliance with the ASTM F 1951 standard....
-
Accessible Means of Entry to Spas
Sections 242.4 and 1009.2, 1009.4, and 1009.5 of the 2010 Standards require spas to meet accessibility requirements, including an accessible means of entry....
-
§ 1194.23(j)
(j) Products that transmit or conduct information or communication, shall pass through cross-manufacturer, non-proprietary, industry-standard codes, translation protocols, formats or other...
