ETA Editor's Note Implications of 11B-404.3.2: Power-assist devices (ANSI/BHMA A156.19) cannot substitute for required door maneuvering clearances, even if standby power is provided....
Search Results "Contract Provider"
Filters
Commonly Searched Documents
-
11B-404.3.2 Maneuvering clearance
-
C102.7.2 ITU-T Recommendation E.161
The G.722 coder-decoder program provides 7 kHz wideband audio at data rates from 48, 56, and 64 kbits/s....
-
Shower Stalls [4.21]
ADAAG provides specifications for several types of shower stall designs: roll-in, transfer, and, in hotels (section 9), a combination of the two....
-
E102.7 International Telecommunications Union Telecommunications Standardization Sector (ITU-T)
The G.722 coder-decoder program provides 7 kHz wideband audio at data rates from 48, 56, and 64 kbits/s....
-
409.1 General
Where transactional outputs are provided by ICT with speech output, the speech output shall audibly provide all information necessary to complete or verify a transaction....
-
Typical Issues
An accessible entrance must provide at least one accessible door with maneuvering space, accessible door hardware, and enough clear width to allow people who use crutches, a cane, walker...
-
Example of a Single-User Bathroom (with Roll-in Shower)
Recommendation: Consider providing turning space outside the shower so that people using wheelchairs do not have to travel on wet surfaces every time they use the room....
-
Doors [4.35.3]
In rooms with curtained openings, clear floor space requirements for alcoves in 4.2.4 must be provided....
-
505.6 Gripping Surface
Where provided, horizontal projections shall occur 1 1/2 inches (38 mm) minimum below the bottom of the handrail gripping surface. EXCEPTIONS: 1....
-
1014.2.1 Transfer Access
Where transfer access is provided, this section requires a clear ground space 36 inches minimum by 48 inches minimum positioned for a parallel approach to be provided at the entrance to...
-
Can doors swing into required clear floor or ground space?
power assisted doors and gates (404.3.5) fixture clearances in toilet and bathing facilities (except those that are single user where wheelchair space beyond the door swing is provided...
-
1.1.16 Alternate measurement tools
Ramps may be measured with instruments other than a digital inclinometer if they provide the data required for evaluation of tolerances as given in Sections 1.2.5, 1.2.6, and 1.2.7....
-
Is vertical access required to all levels of a parking garage?
Vertical access must be provided as necessary to address any changes in level along these required accessible routes....
-
C. Training
Prior to each election during the term of this Agreement, the County will provide training to Highway Department personnel on how to implement the temporary remedies (e.g...
-
§ 38.83(b)(2)(i) Requirements
The controls shall be interlocked with the vehicle brakes, propulsion system, or door, or shall provide other appropriate mechanisms or systems, to ensure that the vehicle cannot be moved...
-
11B-216.7 Elevators
Existing buildings that have been remodeled to provide specific elevators for public use that comply with these building standards shall have the location of and the directions to these...
-
11B-607.2 Clearance
Where a permanent seat is provided at the head end of the bathtub, the clearance shall extend 12 inches (305 mm) minimum beyond the wall at the head end of the bathtub....
-
§ 38.23(b)(2)(i) Requirements
The controls shall be interlocked with the vehicle brakes, transmission, or door, or shall provide other appropriate mechanisms or systems, to ensure that the vehicle cannot be moved when...
-
11B-810.6 Rail station signs
Emerging technologies such as an audible sign system using infrared transmitters and receivers may provide greater accessibility in the transit environment than traditional Braille and raised...
-
11B-404.3.2 Maneuvering clearance
ETA Editor's Note Implications of 11B-404.3.2: Power-assist devices (ANSI/BHMA A156.19) cannot substitute for required door maneuvering clearances, even if standby power is provided....
-
§ 38.159(d)(2) Location and size
Not more than 6 inches (150 mm) of the required clear floor space may be accommodated for footrests under another seat, modesty panel, or other fixed element provided there is a minimum...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
1134A.4 Sufficient maneuvering space
Bathing and toilet facilities required to be adaptable shall provide sufficient maneuvering space for a person using a wheelchair or other mobility aid to enter and close the door, use the...
-
§ 38.159(c)(8) Handrails
If provided, handrails shall allow persons with disabilities to grasp them from outside the vehicle while starting to board, and to continue to use them throughout the boarding process,...