Aisles between round tables require at least three feet of space between the tables (measured from the back of one chair to the back of the chair directly behind it)....
Search Results "Back Support"
Filters
Commonly Searched Documents
-
Accessible Round Table Style
-
Usable
In addition, companies must provide functionally equivalent access to support services, such as technical support hotlines and databases, call centers, service centers, repair services and...
-
11B-608.3.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....
-
§ 38.93(d)(3) Exception
Where platform set-backs do not allow the horizontal gap or vertical alignment specified in paragraph (d)(1) or (d)(2) of this section, car, platform or portable lifts complying with §38.95...
-
11B-604.8.1.4 Toe clearance
provide a toe clearance of 9 inches (229 mm) minimum above the finish floor and 6 inches (152 mm) deep minimum beyond the compartment-side face of the partition, exclusive of partition support...
-
11B-306.1 General
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support for an element....
-
ELECTRIC VEHICLE (EV)
For the purpose of this code, off-road, self-propelled electric vehicles, such as industrial trucks, hoists, lifts, transports, golf carts, airline ground support equipment, tractors, boats...
-
NPRM
Suppose a passenger asks for a round trip from Point A to Point B and back to Point A, or asks for a trip from Point A to Point B to Point C, with a return to Point A....
-
Landscape Forms Inc. Plexus Bench Collection
Metal grid seats stays cool in the sun; dry quickly after rain Constructed of durable metal grid welded to 7/8in. o.d. tubular steel frames Backed or backless Armrests are 7/8in. o.d...
-
F. Paperwork Reduction Act
equipment to provide accessible support documentation and services, which constitute “collection of information” under the PRA....
-
7.2(2)(iii)
shelf attached to the main counter on which an individual with disabilities can write, and (2) use of the space on the side of the counter or at the concierge desk, for handing materials back...
-
4.1.4 Clear Floor or Ground Space
At least 48 inches (1220 mm) of clear floor or ground space shall surround the usable sides of a picnic table, measured from the back edge of the benches....
-
406.8--Modification to 406 of Appendix D to 36 CFR Part 1191
warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured from the back...
-
11B-809.2.2 Turning space
However, the overlap of turning space must be limited to one segment of the T-turn so that back-up maneuvering is not restricted....
-
11B-604.6 Flush controls
If plumbing valves are located directly behind the toilet seat, flush valves and related plumbing can cause injury or imbalance when a person leans back against them....
-
Bobrick Swing-Up Grab Bar B-4998.99
Swing-up grab bar shall be manually raised for approach or departure and lowered to horizontal position for support; counterweighted design shall prevent grab bar from falling back down...
-
5.8.2.7.1 Mammography Chair Footrest Recommendation
Recommendation The Committee recommends that the mammography chair meet the elements of M302 with the additional requirement that any footrests must accommodate and ride over the base support...
-
504.3 Prompts (Section-by-Section Analysis)
504.3 Prompts (Section-by-Section Analysis) This proposed section would require authoring tools to proactively support the creation of accessible content by providing a mode of operation...
-
§ 38.159(c)(1) Design load
Ramps 30 inches (760 mm) or longer shall support a load of 600 pounds (2665 N), placed at the centroid of the ramp distributed over an area of 26 inches by 26 inches (660 mm by 660 mm),...
-
Handrail
Handrail—A narrow railing to be grasped with the hand for support....
-
TownSteel Resetting factory mode for XCE XME 2000 series
How to put the XCE XME 2000 series lock back into factory mode. One method with the master code and the other without the master code...
-
3. Modified Theaters
Therefore, when wheelchair spaces are relocated one or more row[s] farther back from the screen, that movement is measured from the existing seating plan....
-
3. Buttock-Popliteal Length
., crease at the back of the knee) of the right leg. The median buttock-popliteal length provides an upper bound for the depth of a seating surface....
-
Guiding Techniques
When seating the guest, ask if you may show him or her the back of the chair. If the response is yes, simply place the guest’s hand on the chair back....
