Frames supported by diagonal braces of 1-5/16” OD steel pipe attached to center channel. Frames are welded into a single piece structure for strength and easy assembly. ...
Search Results "Enhanced 9-1-1"
-
Pilot Rock WXT and WXTH Picnic Table Using Expanded Steel
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
The reference points and planes, body points and WhMD points, and some of their application are listed in Tables 2‒1 and 2‒2. Table 2‒1....
-
Bradley Fixed Tilt Mirror with Shelf 7405
Fixed Tilt Mirror Satin finish Stainless Steel frame 5-1/2" shelf welded to bottom of frame...
-
§1607.7 Use of other validity studies.
conducted by one test user, or described in test manuals and the professional literature, will be considered acceptable for use by another user when the following requirements are met: (1)...
-
What Testing Accommodations Must Be Provided?
. § 35.130(b)(1)(iii), and may not administer a licensing or certification program in a manner that subjects qualified individuals with disabilities to discrimination on the basis of disability...
-
15. When may an employer refuse to hire, terminate, or temporarily restrict the duties of a person who has or had a hearing impairment because of safety concerns?
The employer also must consider: (1) the duration of the risk; (2) the nature and severity of the potential harm; (3) the likelihood that the potential harm will occur; and...
-
C. The 2014 Notice of Proposed Rulemaking on Movie Captioning and Audio Description
the 2010 ANPRM and the rapid rate at which movie theaters were converting from analog to digital projection systems, the Department published a Notice of Proposed Rulemaking on August 1,...
-
Section 1193.33 Accessibility and usability
Section 1193.33 Accessibility and usability Section 1193.33 requires that, where readily achievable, manufacturers must (1) provide a description of the accessibility and compatibility...
-
DEFINITIONS
. § 36.303(b)(1)....
-
M305.2.4 Cross Section (Section-by-Section Analysis)
Specifically, the Access Board indicated it was considering requiring circular cross sections to have an outside diameter of 1¼ inches minimum and 2 inches maximum, and transfer supports...
-
Passing Spaces [1017.4]
When passing spaces and resting intervals overlap, the technical requirements for resting intervals apply and the slope of the ground surface must be no steeper than 1:48 (2 percent) in...
-
40. Must an employer ask whether a reasonable accommodation is needed when an employee has not asked for one?
inform the employer that an accommodation is needed.(108) However, an employer should initiate the reasonable accommodation interactive process(109) without being asked if the employer: (1)...
-
Section 35.150(b)(2) Safe Harbor (Section-by-Section Analysis)
public accommodations under title III, a public entity is not required to make each of its existing facilities accessible to and usable by individuals with disabilities. 28 CFR 35.150(a)(1)...
-
11B-216.6 Entrances
.◼ Exceptions: 1. ...
-
c) Changes
This Pocket Guide is based on the initial publication of 2013 CBC, with Errata issued retroactive to January 1, 2014, and the Supplement dated July 1, 2015....
-
Requirement to block accessible guest room reservations. (Section-by-Section Analysis)
For that reason, the Department has added § 36.302(e)(1)(iv) to the final rule....
-
Trash, Recycling, and Other Essential Containers
The slope of the clear space must not be steeper than 1:48 (2 percent) in any direction....
-
Clear Tread Width and Passing Spaces for Outdoor Recreation Access Routes
The cross slope of a passing space must not exceed 1:33 (3 percent)....
-
III-6.1000 General
ILLUSTRATION 1: Flooring in a store is being replaced. This is an alteration because it can affect whether or not an individual in a wheelchair can travel in the store....
-
2. Amended TTY Requirements
In Table 1 below, we provide a “cross-walk” that lists the TTY-related provisions added by the direct final rule and identifies their corresponding provisions in the original 508 Standards...
-
28 CFR Parts 35 and 36 Amendment of ADA Title II and Title III Regulations To Implement ADA Amendments Act of 2008 - Final Rule
Act (ADA) regulations in order to incorporate the statutory changes to the ADA set forth in the ADA Amendments Act of 2008 (ADA Amendments Act or the Act), which took effect on January 1,...
-
Large Print (Advisory Guidance)
Always use 1 inch margins. Lines longer than 6 inches will not track well for individuals who must use a magnifier. b....
-
11B-404.2.7 Door and gate hardware
Exceptions: 1....
-
II-3.3000 Equality in participation/benefits
ILLUSTRATION 1: A deaf individual does not receive an equal opportunity to benefit from attending a city council meeting if he or she does not have access to what is said....
