Section 405.2 covers the current ADA Standards for slope requirements on ramps.
Search Results "Comply With"
-
Slope: ADA Standard Section 405.2
-
1009.8 Two-way communication
A two-way communication system complying with Sections 1009.8.1 and 1009.8.2 shall be provided at the landing serving each elevator or bank of elevators on each accessible floor that is...
-
11B-1008.2.3 Water play components
Transfer systems complying with Section 11B-1008.3 shall be permitted to connect elevated play components in water. Advisory 11B-1008.2.3 Water play components....
-
Carpet: ADA Standard Section 302.2
Section 302.2 covers the current ADA Standards for carpet.
-
11B-809.8.3 Door maneuvering clearance.
Minimum maneuvering clearances at doors shall comply with Section 11B-809.8.3. ...
-
11B-1008.2.3 Water play components
Transfer systems complying with Section 11B-1008.3 shall be permitted to connect elevated play components in water. Advisory 11B-1008.2.3 Water play components....
-
11B-221.6 Semi-ambulant seats
At least 1 percent of the total number of seats, and no fewer than two, shall be semi-ambulant seats complying with Section 11B-802.5....
-
11B-221.6 Semi-ambulant seats
At least 1 percent of the total number of seats, and no fewer than two, shall be semi-ambulant seats complying with Section 11B-802.5....
-
11B-1003.3.2 Boarding pier clearances
The entire length of accessible boarding piers would be required to comply with the same technical provisions that apply to accessible boat slips....
-
11B-1003.3.2 Boarding pier clearances
The entire length of accessible boarding piers would be required to comply with the same technical provisions that apply to accessible boat slips....
-
11B-223 Medical care and long-term care facilities
requirements of Section 11B-223 shall apply only to the patient bedrooms or resident sleeping rooms being altered or added until the number of patient bedrooms or resident sleeping rooms complies...
-
Use of the International Symbol of Accessibility and Other Signs
Where all constructed features and areas comply with the accessibility provisions, you may post ISA, but it is not required....
-
C.
stadium-style movie theaters – that were designed and constructed for first occupancy after January 26, 1993, must be readily accessible to and useable by persons with disabilities by complying...
-
§382.61(e)
(e) You are not required to retrofit cabin interiors of existing aircraft to comply with the requirements of this section....
-
M305.2.1 Location
Transfer supports shall comply with M305.2.1.1 or M305.2.1.2 and shall be located 1 ½ inches (38 mm) maximum measured horizontally from the plane defined by the nearest edge of the transfer...
-
11B-612.2 Bench
Where seating is provided in saunas and steam rooms, at least one bench shall comply with Section 11B-903....
-
M301.4 Lift Compatibility
Diagnostic equipment shall be usable with portable patient lifts and, when in use with such lifts, shall comply with M301.4.1 or M301.4.2....
-
407.2.3.2 Car Designations
Destination-oriented elevators shall provide tactile car identification complying with 703.2 on both jambs of the hoistway immediately below the floor designation....
-
M302.4 Lift Compatibility
Diagnostic equipment shall be usable with portable patient lifts and, when in use with such lifts, shall comply with M302.4.1 or M302.4.2. ...
-
SECTION 1008 DOORS, GATES AND TURNSTILES
egress from, buildings or facilities where accessibility is required for applications listed in Section 1.9.1 regulated by the Division of the State Architect—Access Compliance, shall also comply...
-
Dressing, Fitting, or Locker Rooms
Dressing, Fitting, or Locker Rooms When provided, dressing, fitting, or locker rooms must be accessible and comply with all ADAAG provisions....
-
405.9.1 Extended Floor or Ground Surface
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
F225.3.1 Dispersion
Self-service storage spaces complying with Table F225.3 shall not be required to be dispersed among buildings in a multi-building facility....
-
General (R302.1) (Section-by-Section Analysis)
In alterations where existing physical constraints make it impractical to fully comply with the technical requirements, compliance is required to the extent practicable within the scope...