The standards provide for independent access to and use of diagnostic equipment by patients with disabilities to the maximum extent possible....
Search Results "Building Use"
Commonly Searched Documents
-
M101.1 Purpose
-
11B-705.1.2.1 Platform edges
Detectable warning surfaces at platform boarding edges shall be 24 inches (610 mm) wide and shall extend the full length of the public use areas of the platform....
-
§ 37.185(b)
2012, 100 percent of the buses in its fleet with which it provides fixed-route service are readily accessible to and usable by individuals with disabilities, including individuals who use...
-
§ 38.21(a)
(a) New, used or remanufactured buses and vans (except over-the-road buses covered by subpart G of this part), to be considered accessible by regulations in part 37 of this title shall comply...
-
11B-407.4.10.3 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the support rail, fastener, mounting device...
-
11B-609.8 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the grab bar, fastener, mounting device,...
-
Employee Parking Lot
Question: Is there a difference between parking spaces marked or reserved for employees and parking spaces that are just in the back of the building, unmarked but intended for employees?...
- Walk-A-Sured Roll-On Anti-Slip Safety Coating System
- Guldmann GH3 Twin Lifting Module
- Hill-Rom Likorall™ Overhead Lift, Traverse with Upright Supports
-
Issue 1: APS volume
An APS signal should be audible at the beginning of the crosswalk, but no more than 3.7 m (12 ft) from the pushbutton, or to the building line, whichever is closer (2003 MUTCD)....
-
11B-104.1.1 Construction and manufacturing tolerances
Information on specific tolerances may be available from industry or trade organizations, code groups and building officials, and published references....
-
11B-104.1.1 Construction and manufacturing tolerances
Information on specific tolerances may be available from industry or trade organizations, code groups and building officials, and published references. ...
- Tenon LLC
- Accessibility Professionals Association (APA)
- Lynchburg Area Center for Independent Living (LACIL) - Lynchburg, VA
-
Priorities for Barrier Removal
In some instances, especially in older buildings, it may not be readily achievable to remove some architectural barriers....
-
C. Establishing and Publishing Grievance Procedures
Post copies in public spaces of public building and on the government’s website. Update the procedure and the contact information as necessary....
-
2. Written Communications
For example, if there are brief written instructions on how to get to an office in a public building, it is often effective to read the directions aloud to the person....
-
Alterations to Residential Facilities
The scoping requirements for alterations to dwelling units generally are based on the requirements in the UFAS: • Where a building is vacated for purposes of alterations and has more...
-
Egress Signage
In the final rule, scoping requirements for means of egress and areas of refuge have been revised to reference provisions in the International Building Code (IBC) as discussed above in section...
-
1129B.3, Item 2
ETA Editor's Note Select portions of the 2010 California Building Code (2010 CBC) are provided for reference only....
-
1131B.2, Item 1
ETA Editor's Note Select portions of the 2010 California Building Code (2010 CBC) are provided for reference only....
-
Where can I learn more about accessibility?
The GSA Accessibility Website provides information about accessibility requirements for buildings owned and managed by the General Services Administration, the "landlord" for the Federal...