In transfer type compartments, grab bars shall be provided across the control wall and back wall to a point 18 inches (455 mm) from the control wall....
Search Results "NTTAA: National Technology Transfer and Advancement Act of 1995"
-
608.3.1 Transfer Type Shower Compartments
-
1002.5 Amusement Ride Seats Designed for Transfer
Amusement ride seats designed for transfer shall comply with 1002.5 when positioned for loading and unloading. Advisory 1002.5 Amusement Ride Seats Designed for Transfer....
-
1002.5 Amusement Ride Seats Designed for Transfer
Amusement ride seats designed for transfer shall comply with 1002.5 when positioned for loading and unloading. Advisory 1002.5 Amusement Ride Seats Designed for Transfer....
-
Ramp
Ramp: A ramped surface was designed to insert between two steps and serve as an integrated sliding board to assist with the transfers by bridging the gap between steps. ...
-
11B-1008.2.2 Soft contained play structures
Exception: Transfer systems complying with Section 11B-1008.3 shall be permitted to be used as part of an accessible route....
-
11B-1008.2.2 Soft contained play structures
Exception: Transfer systems complying with Section 11B-1008.3 shall be permitted to be used as part of an accessible route....
-
Best Practices in the Design of Toileting and Bathing Facilities for Assisted Transfers
Best Practices in the Design of Toileting and Bathing Facilities for Assisted Transfers Final Report August 1, 2001 Jon A....
-
Clear Floor Space: ADA Standard Section 1004.1
Exercise machines and equipment shall have a clear floor space complying with 305 positioned for transfer or for use by an individual seated in a wheelchair....
-
General: ADA Standard Section 233.1
Section 233 of the ADA Standards covers information in the current ADA Standards on scoping requirements for residential facilities.
-
§ 1194.3(e)
(e) This part shall not be construed to require a fundamental alteration in the nature of a product or its components.
-
§ 1194.31(d)
(d) Where audio information is important for the use of a product, at least one mode of operation and information retrieval shall be provided in an enhanced auditory fashion, or...
-
§ 1194.3(f)
(f) Products located in spaces frequented only by service personnel for maintenance, repair, or occasional monitoring of equipment are not required to comply with this part.
-
E202.4 Federal Contracts
ICT acquired by a contractor incidental to a contract shall not be required to conform to the Revised 508 Standards.
-
414.1.2 Other ICT
ICT other than digital television tuners shall provide audio description processing.
-
412.2.2 Volume Gain for Non-Wireline ICT
A method for increasing volume shall be provided for non-wireline ICT.
-
701.1 Scope
The standards referenced in Chapter 7 shall apply to ICT where required by 508 Chapter 2 (Scoping Requirements), 255 Chapter 2 (Scoping Requirements), and where referenced in any...
-
Chapter 7: Referenced Standards
[See subsections ...]
-
702 Incorporation by Reference
[See subsections ...]
-
408 Display Screens
[See subsections ...]
-
407.8 Reach Height and Depth
At least one of each type of operable part of stationary ICT shall be at a height conforming to 407.8.2 or 407.8.3 according to its position established by the vertical reference...
-
602.1 General
Documentation that supports the use of ICT shall conform to 602.
-
Defining Requirements for EIT
[See subsections ...]
-
B.2.i. - What must an agency do to ensure its' acquisitions of EIT provide "comparable access"?
Unless an exception applies, an agency’s obligation to provide comparable access under Section 508 is satisfied by acquiring EIT that meets the applicable technical provisions in...
-
B.6.iii. - Is undue burden the only grounds for acquiring EIT that does not meet the applicable technical provisions?
No. There are several exceptions to the requirements of Section 508 (see section G).