Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
Search Results "Horizontal Exit"
Commonly Searched Documents
- 
    
  
  11B-903.6 Structural strength
  
 - 
    
  
  HANDRAIL
  
A horizontal or sloping rail intended for grasping by the hand for guidance or support....
 - 
    
  
  HANDRAIL
  
A horizontal or sloping rail intended for grasping by the hand for guidance or support....
 - 
    
  
  HANDRAIL
  
A horizontal or sloping rail intended for grasping by the hand for guidance or support....
 - 
    
  
  Slope Ratio
  
Slope Ratio—A ratio of vertical distance to horizontal distance or rise to run....
 - 
    
  
  Will a Person Who is Blind or Has Low Vision Require Assistance to Use the Circulation Path?
  
It is important to verify that a person who is blind or has low vision can travel unassisted through the exit access, the exit, and the exit discharge to a public way....
 - 
    
  
  4.6.5* Vertical Clearance
  
Provide minimum vertical clearance of 114 in (2895 mm) at accessible passenger loading zones and along at least one vehicle access route to such areas from site entrance(s) and exit(s)....
 - 
    
  
  11B-505.10.3 Bottom extension at stairs
  
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance equal to one tread depth beyond the last riser nosing....
 - 
    
  
  11B-407.3.1 Type
  
Elevator doors shall be the horizontal sliding type. Car gates shall be prohibited....
 - 
    
  
  407.3.1 Type
  
Elevator doors shall be the horizontal sliding type. Car gates shall be prohibited....
 - 
    
  
  407.3.1 Type
  
Elevator doors shall be the horizontal sliding type. Car gates shall be prohibited....
 - 
    
  
  11B-407.3.1 Type
  
Elevator doors shall be the horizontal sliding type. Car gates shall be prohibited....
 - 
    
  
  11B-407.3.1 Type
  
Elevator doors shall be the horizontal sliding type. Car gates shall be prohibited....
 - 
    
  
  Back Support: ADA Standard Section 903.4
  
Back support shall be 2½ inches (64 mm) maximum from the rear edge of the seat measured horizontally. Advisory 903.4 Back Support....
 - 
    
  
  Ground Level Play Component
  
A play component that is approached and exited at the ground level....
 - 
    
  
  106.5.33 Ground Level Play Component
  
A play component that is approached and exited at the ground level....
 - 
    
  
  G. Areas of Rescue Assistance
  
fire sprinkler system serving every room, are there two 30"x48" wheelchair waiting areas (a.k.a. an "area of rescue assistance" linked to the primary entry by intercom) at each required exit...
 - 
    
  
  609.4 Position of Grab Bars
  
Grab bars shall be installed in a horizontal position, 33 inches (840 mm) minimum and 36 inches (915 mm) maximum above the finish floor measured to the top of the gripping surface, except...
 - 
    
  
  609.4 Position of Grab Bars
  
Grab bars shall be installed in a horizontal position, 33 inches (840 mm) minimum and 36 inches (915 mm) maximum above the finish floor measured to the top of the gripping surface, except...
 - 
    
  
  239.3 Miniature Golf Course Configuration
  
Miniature golf courses shall provide an accessible route from the last hole complying with 1007.3 to the course entrance or exit without requiring travel through any other holes on the course...
 - 
    
  
  11B-239.3 Miniature golf course configuration
  
Miniature golf courses shall provide an accessible route from the last hole complying with Section 11B-1007.3 to the course entrance or exit without requiring travel through any other holes...
 - 
    
  
  F239.3 Miniature Golf Course Configuration
  
Miniature golf courses shall provide an accessible route from the last hole complying with 1007.3 to the course entrance or exit without requiring travel through any other holes on the course...
 - 
    
  
  Accessible Routes
  
The course must be configured to allow an easy exit from the last accessible hole to the facility exit or entrance....
 - 
    
  
  239.3 Miniature Golf Course Configuration
  
Miniature golf courses shall provide an accessible route from the last hole complying with 1007.3 to the course entrance or exit without requiring travel through any other holes on the course...