Access aisles shall be at the same level as the vehicle pull-up space they serve. Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted....
Search Results "Floor-Level Exit Sign"
Filters
Commonly Searched Documents
-
11B-503.4 Floor and ground surfaces
-
11B-411.1.1 Floor designations
Floor designations shall be "one" (1) or "zero" (0) at the main entry level and shall increase by one for each successive higher story or level....
-
11B-411.1.1 Floor designations
Floor designations shall be "one" (1) or "zero" (0) at the main entry level and shall increase by one for each successive higher story or level....
-
11B-411.1.1 Floor designations
Floor designations shall be "one" (1) or "zero" (0) at the main entry level and shall increase by one for each successive higher story or level....
-
11B-411.4.11.1 Height
Floor destination characters shall be 1 inch (25 mm) high minimum complying with Section 11B-703.5.3....
-
What is the minimum level of slip resistance required by the standards?
The standards require ground and floor surfaces to be slip resistant, but they do not specify a minimum level of slip resistance or coefficient of friction. ...
-
11B-411.2.1.6 Identification of floors served
In buildings with two or more elevator banks, each serving a different group of specific floors, hall call consoles located on floors with a building entry, including parking and transfer...
-
11B-411.2.1.6 Identification of floors served
In buildings with two or more elevator banks, each serving a different group of specific floors, hall call consoles located on floors with a building entry, including parking and transfer...
-
Is compliance on both sides of a door or gate required when it is usable only from one side?
Examples include exit-only doors with no operating hardware on the exterior side or separate enter and exit fare gates in transit stations....
-
1009.2 Continuity and components
Exterior exit stairways complying with Sections 1009.3 and 1027 and Chapter 11A, Section 1115A, or Chapter 11B, Sections 11B-210 and 11B-504, as applicable and serving levels other than...
-
Seton Parking Signs - Van Accessible with ISA
Symbol of Access Signs are available in economical non-reflective steel or .063" Engineer Grade reflective aluminum to improve sign visibility at night Extend the life and...
-
11B-411.4.6.2 Buttons
The car shall not have non-functional, exposed floor buttons....
-
302 Floor or Ground Surfaces
302 Floor or Ground Surfaces...
-
403.2 Floor or Ground Surface
Floor or ground surfaces shall comply with 302....
-
403.2 Floor or Ground Surface
Floor or ground surfaces shall comply with 302....
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
-
G2
Is the accessible route free of steps and abrupt level changes over 1/2 inch? Yes No Note: level changes between 1/4 inch and 1/2 inch should be beveled)....
-
11B-410.2 Floor surfaces
Floor surfaces in platform lifts shall comply with Sections 11B-302 and 11B-303....
-
11B-410.2 Floor surfaces
Floor surfaces in platform lifts shall comply with Sections 11B-302 and 11B-303....
-
11B-410.2 Floor surfaces
Floor surfaces in platform lifts shall comply with Sections 11B-302 and 11B-303....
-
11B-504.4 Tread surface
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted. Exception: Reserved....
-
Identification: ADA Standard Section 502.6
Section 502.6 covers the current ADA Standards for parking space identification signs.
-
11B-231.3.2 Court-floor holding cells
Where separate court-floor holding cells are provided for adult male, juvenile male, adult female, or juvenile female, each courtroom shall be served by one cell of each type complying with...
-
11B-502.8.2 Lettering
The additional sign shall clearly state in letters with a minimum height of 1 inch (25 mm) the following: "Unauthorized vehicles parked in designated accessible spaces not displaying...
