Flush controls shall be hand operated or automatic, and shall comply with 4.27.4, and shall be mounted no more than 44 in (1120 mm) above the finish floor....
Search Results "Sign Clear Floor Space"
Filters
Commonly Searched Documents
-
4.18.4 Flush Controls
-
903.5 Height
The top of the bench seat surface shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the finish floor or ground. ...
-
306.3.2 Maximum Depth
Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (230 mm) above the finish floor or ground....
-
4.4.2 Height
The front edge of the seat of a bench shall be at least 17 inches (430 mm) and no more than 19 inches (485 mm) above the floor or ground. ...
-
11B-306.3.2 Maximum depth
Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (229 mm) above the finish floor or ground....
-
§ 38.113(d)(2) Exception
New cars operating in existing stations may have a floor height within plus or minus 11/2 inches of the platform height....
-
11B-903.5 Height
The top of the bench seat surface shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the finish floor or ground....
-
11B-903.5 Height
The top of the bench seat surface shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the finish floor or ground....
-
11B-306.3.2 Maximum depth
Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (229 mm) above the finish floor or ground....
-
11B-608.1 General
Shower stalls that are 60 inches (1525 mm) wide and have no curb may increase the usability of a bathroom because the shower area provides additional maneuvering space. ◼...
-
Angled (Front-In) Parking
ADAAG's requirement for an access aisle on either side of a space (they can be shared by two spaces) is based on the assumption that drivers can head in or back in as needed....
-
F202.3 Alterations
The final rule adds Exception 4 to this section, which applies to altered elements and spaces....
-
Neo-Metro Commercial Wall Mounted Pat Basin Featuring Dyson® Airblade™ Tap/Hand Dryer
A Commercial Floor Mounted Arm/Carrier (-MC-FLR) is highly recommended for commercial applications....
-
Parking
Parking The chart below indicates the number of accessible spaces required by the 2010 Standards. One out of every six accessible spaces must be van-accessible....
-
11B-608.5.3 Alternate roll-in type shower compartments
seat wall 19 inches (483 mm) minimum and 27 inches (686 mm) maximum from the seat wall; and shall be located above the grab bar, but no higher than 48 inches (1219 mm) above the shower floor...
-
11B-608.5.3 Alternate roll-in type shower compartments
seat wall 19 inches (483 mm) minimum and 27 inches (686 mm) maximum from the seat wall; and shall be located above the grab bar, but no higher than 48 inches (1219 mm) above the shower floor...
-
Whitehall Mfg. Hot & Cold Piezo Widespread Pushbutton Electronic Valve Conical Faucet
As loose components, the spout and pushbutton may be installed with any centerset spacing, however, 4", 6" or 8" centersets are suggested....
-
Whitehall Mfg. 3373-WSF Single Temp Hemispherical Widespread Pushbutton Pneumatic Valve Conical Faucet
As loose components, the spout and pushbutton may be installed with any centerset spacing, however, 4", 6" or 8" centersets are suggested....
-
Whitehall Mfg. Single Temp Hemispherical Widespread Pushbutton Pneumatic Valve Conical Faucet
As loose components, the spout and pushbutton may be installed with any centerset spacing, however, 4", 6" or 8" center sets are suggested....
-
Inclusion Solutions Temporary Lot Paint (Case of 12) Blue
Lot Paint, Temporary Parking Stop clearly defines parking space for temporary or pemanent use Each case of paint will mark over 100 spaces Mark will disappear in...
-
Inclusion Solutions Poll Star Voting Booth
Superior design and precision manufacturing offer you the following benefits; lightweight, minimal storage space requirements, attractive design, and low cost....
-
Shopping Center or Shopping Mall
The facility housing a “shopping center or shopping mall” only includes floor levels housing at least one sales or rental establishment, or any floor level designed or intended for use by...
-
609.4 Position of Grab Bars
Grab bars shall be installed in a horizontal position, 33 inches (840 mm) minimum and 36 inches (915 mm) maximum above the finish floor measured to the top of the gripping surface, except...
