Section 4.2.1 of the ADAAG requires a minimum clear width of 0.815 m (32 inches) at a point, and 0.915 m (36 inches) continuously, for single wheelchair passage....
Search Results "Pedestrian Access Point"
-
Path Width
-
18.1 Q. Is it necessary to provide usable doors when the door leads to an area of the dwelling that is not accessible, such as the door leading down to an unfinished basement...?
This will ensure that, if a wheelchair user occupying the dwelling unit chooses to modify the unit to provide accessibility to these areas, such as installing a ramp from the dwelling unit...
- Behavioral Safety Products #DH510 Mortise Ligature Resistant Integrated Door Lever
- Technibilt Caroline's Cart
-
Low Vision and Blindness
And of course, the smaller the fraction – 20/20, is one; 20/200, point-one....
-
Prominent Feature
A prominent feature may be the focal point, main attraction, or destination of a trail, or it may simply be an interesting secondary feature. ...
-
608.2.1 Transfer Type Shower Compartments
Transfer type shower compartments shall be 36 inches (915 mm) by 36 inches (915 mm) clear inside dimensions measured at the center points of opposing sides and shall have a 36 inch (915...
-
SHOPPING CENTER (OR SHOPPING MALL)
A shopping center may include a series of buildings on a common site, connected by a common pedestrian access route on, above or below the ground floor, that is either under common ownership...
-
Link Broken
Requires the Accessibility Specialist plan or above. (Login or upgrade your account!)
-
Section 36.404 Alterations: Elevator Exemption (Section-By-Section Analysis and Response to Comments)
section, a "shopping center or shopping mall'' is (1) a building housing five or more sales or rental establishments, or (2) a series of buildings on a common site, connected by a common pedestrian...
-
Trail Construction Techniques
Numerous illustrations help explain the main points. The notebook is at http://www.fhwa.dot.gov/environment/fspubs/07232806/index.htm....
-
Re: 216 Signs
The international symbol for accessibility shall be used at each accessible entrance of a facility." ...
-
How to Use This Pocket Guide
Design (MGRAD) or the Uniform Federal Accessibility Standards (UFAS) to remain until they are altered. ...
-
1010.1.9.7 Delayed egress locks
For applications listed in Section 1.9.1 regulated by the Division of the State Architect-Access Compliance, see Chapter 11B, Section 11B-404.2.9....
-
Block Blast
Block Blast rewards streaks, so consecutive clears give much higher points. I try to set up the board to trigger these combos....
- Pilot Rock PQT3-4 Square Pedestal Table Using Recycled Plastic
- Pilot Rock PQT3-4 Square Pedestal Table Using Lumber
-
Ticket transfer. (Section-by-Section Analysis)
Some commenters pointed out that the NPRM proposed explicitly allowing individuals with disabilities holding season tickets to transfer tickets but did not address the transfer of tickets...
-
Ticket transfer. (Section-by-Section Analysis)
Some commenters pointed out that the NPRM proposed explicitly allowing individuals with disabilities holding season tickets to transfer tickets but did not address the transfer of tickets...
- Clarity Ensemble Amplified Captioned Telephone
-
Comments from Individuals Who Are Blind or Have Low Vision (Section-by-Section Analysis)
the proposed guidelines, but filed a minority report recommending detectable warning surfaces should be required only on curb ramps with slopes of 6.6 percent or less, and at medians and pedestrian...
-
Are side flares required at curb ramps?
Side flares are advisable where pedestrian traffic may cross runs to prevent tripping hazards....
-
Section 1193.51 Compatibility [1193.41 in the NPRM] (Section-by-Section Analysis)
Section 1193.51 Compatibility [1193.41 in the NPRM] (Section-by-Section Analysis) Section 1193.51 requires that when it is not readily achievable to make a product accessible, the product...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....