The floor or ground area within the required clearances shall be level and clear....
Search Results "Extended Floor Surface"
-
4.13.6 MANEUVERING CLEARANCES AT DOORS
-
Horizontal Exits [IBC §1021 (2003), §1005.3.5 (2000)]
allowing occupants to exit the area containing the origin of a fire into another portion of the building that is protected by fire-resistance-rated assemblies (doors, walls, ceilings, and floors...
-
11B-605.4 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except that the flush control shall be mounted at a maximum height of 44 inches (1118 mm) above the finish floor....
-
Meeting ANSI Standard S12.60 Requirements
Reducing Noise Traveling Through the Plenum – Walls do not always extend all the way up to the finished deck of the floor above. Instead they often stop at the suspended ceiling line....
-
Boarding Piers at Boat Launch Ramps
A boat launch ramp is a sloped surface designed for launching and retrieving trailered boats and other watercraft to and from a body of water....
-
Background
The impetus for the National Trails Surface study was to investigate alternatives to the typical firm and stable surface materials of asphalt, concrete, or boardwalk....
-
Wingits Reversible L-shaped 26" x 22.5" Shower Seat
Available in watertight white padded Naugahyde or Phenolic material (solid or slatted in white or teak) 18/8 (304) Stainless Steel frame with fold down legs transfers the load to the floor...
-
Cybex Total Access Upright Bike
This allows fitness enthusiasts who have physical or sensory limitations to take advantage of fitness training on the same gym floor and using the same equipment as those who do not....
-
Text Telephones (TTY)
Section 217.4.2 of the 2010 Standards requires that a building or facility provide a public TTY on each floor that has four or more public telephones, and in each telephone bank that has...
-
RECOMMENDED CHANGE
medical devices, requires a similar instability test in section 9.4.2.3: ME EQUIPMENT having a mass of 25 kg or more, other than FIXED ME EQUIPMENT that is intended to be used on the floor...
-
Examination Tables
Treatment tables typically have a fixed height of 31 inches measured from the floor to the top of the table. The lower cost products have an open base with an H-brace or shelf....
-
II-6.2100 General
If ADAAG is chosen, however, public entities are not entitled to the elevator exemption (which permits certain buildings under three stories or under 3,000 square feet per floor to be constructed...
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Accessible Routes
Accessible route requirements in ADAAG address width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level, doors, egress, and areas...
-
703.7.1 Finish and Contrast
Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
-
Cashier counters
Museum Gift Shop (provide a temporary surface, such as a clipboard, and install a permanent counter within twenty-four months); ii. Spy City Café; and iii....
-
B. Measuring Clear Passage at Doors
The photo below shows that you measure horizontally from the face of the door in its 90 degree open position to the surface of the door stop on the frame opposite the hinge....
-
4. Parking and passenger loading zones
4.6 If provided at the site, designated accessible parking at the dwelling unit on request of residents with handicaps, on the same terms and with the full range of choices (e.g. surface...
-
11B-703.5.1 Finish and contrast
Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
-
11B-703.6.2 Finish and contrast
Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
-
11B-703.7.1 Finish and contrast
Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
-
703.7.1 Finish and Contrast
Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
-
1134A.8, Item 1
The top of the fixture rim shall be a maximum of 34 inches (864 mm) above the finished floor....
-
407.8.2.2 Obstructed Side Reach
more than 24 inches (610 mm), beyond the vertical reference plane, the height of the operable part shall be 46 inches (1170 mm) high maximum and 15 inches (380 mm) high minimum above the floor...
