defenses alleging, among other things, that the DOJ acted unlawfully by attempting to retroactively change the meaning and interpretation of ADA Standard 4.33.3, that the DOJ failed to comply...
Search Results "Comply With"
Filters
Commonly Searched Documents
-
K.
-
11B-233.3.1.2 Residential dwelling units with adaptable features
In public housing facilities with residential dwelling units, adaptable residential dwelling units complying with Chapter 11A, Division IV – Dwelling Unit Features shall be provided as required...
-
703.4.1 Height above Finish Floor or Ground
[ECTCR UFAS 4.30.6] EXCEPTION: Tactile characters for elevator car controls shall not be required to comply with 703.4.1....
-
1132A.5.2 Strike edge maneuvering space at doors
The width of the level area at the exterior side of the primary entry door and any required exit doors shall comply with Section 1126A. Notes: 1. ...
-
604.9.6 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
-
11B-407.2.2.2 Visible signals
Existing elevators shall not be required to comply with 407.2.2.2 FIGURE 11B-407.2.2.2 ‡‡ VISIBLE HALL SIGNALS...
-
1007.8 Two-way communication
A two-way communication system shall be provided at the elevator landing on each accessible floor that is one or more stories above or below the story of exit discharge complying with Sections...
-
M305.2.2.2 Side Transfer Supports
Transfer supports for transfer surfaces complying with M301.2.3.2 shall be 28 inches (710 mm) long minimum and shall be positioned along the width of transfer surfaces....
-
F248.1 General
Beach access routes complying with 1018 shall be provided in accordance with F248.1. Beach access routes shall be permanent or removable....
-
Check-out Aisle Counter Height
Under this requirement, the height of check-writing surfaces, where provided, is to comply with the height of work surfaces addressed in section 902.3 (34 inches maximum), consistent with...
-
502.2 Vehicle Spaces
shall be 96 inches (2440 mm) wide minimum and van parking spaces shall be 132 inches (3350 mm) wide minimum, shall be marked to define the width, and shall have an adjacent access aisle complying...
-
1009.3 Sloped Entries
Sloped entries shall comply with 1009.3. Advisory 1009.3 Sloped Entries. Personal wheelchairs and mobility devices may not be appropriate for submerging in water....
-
707.1 General
Automatic teller machines and fare machines shall comply with 707. Advisory 707.1 General....
-
New Construction
Owners or operators of newly constructed play areas are responsible for complying with these guidelines....
-
Court Sports
Accessible routes must comply with all ADAAG requirements, such as width and changes in level or surface, and must directly connect both sides of the court....
-
403.5.3 Passing Spaces
Passing spaces shall be either: a space 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum; or, an intersection of two walking surfaces providing a T-shaped space complying with...
-
M301.3.1 Transfer Supports (Section-by-Section Analysis)
require transfer supports to be provided for use with transfer sides on diagnostic equipment used by patients in the supine, prone, or side-lying position, and that these transfer supports comply...
-
M302.3.3 Head and Back Support (Section-by-Section Analysis)
Therefore, in the final rule, this provision instructs that where diagnostic equipment is used in a reclined position it must provide head and back support that complies with the technical...
-
M301.3.3 Head and Back Support (Section-by-Section Analysis)
Therefore, in the final rule, this provision instructs that where diagnostic equipment is used in a reclined position it must provide head and back support that complies with the technical...
-
707.1 General
Automatic teller machines and fare machines shall comply with 707. Advisory 707.1 General....
-
F225.2.1 Lockers
Where lockers are provided, at least 5 percent, but no fewer than one of each type, shall comply with 811....
-
Temporary Facilities
Facilities hosting tournaments or competitions must comply with all the other requirements of the ADA, including the general obligation to provide an equal opportunity to individuals with...
-
304.3.2 T-Shaped Space
The space shall be permitted to include knee and toe clearance complying with 306 only at the end of either the base or one arm....
-
Exceptions [1014.1, Exceptions 1 and 2]
When a condition for exception does not permit full compliance with a specific provision in the technical requirements for camp shelters, the camp shelter must comply with the specific provision...