503.5 Vertical Clearance....
Search Results "Vertical Grab Bar"
Filters
Commonly Searched Documents
-
503.5 Vertical Clearance
-
Symmetry Vertical Platform Lift VPC-EL
Features : Nonskid platform surface Obstruction safety panel under platform (when not installed within a runway enclosure) Alarm and emergency stop switch Grab...
-
Head Room [4.4.2]
Circulation paths must provide at least 80 inches of vertical clearance. Otherwise, fixed barriers detectable by canes must define areas with less clearance....
-
11B-809.10.8 Lavatories, vanities, mirrors and towel bars
Where mirrors or towel bars are provided, no less than one of each shall comply with this section....
-
A4.17.3 Size and Arrangement
However, some persons with disabilities who use mobility aids such as walkers, canes or crutches are better able to use the two parallel grab bars in the 36 in (915 mm) wide alternate stall...
-
M305.3.1.3 Vertical Position
The length of the gripping surface on vertical standing supports shall be 18 inches (455 mm) minimum....
-
Garaventa Elvoron CPL Vertical Platform Lift
The Elvoron CPL is a vertical platform lift equipped with a full height cab and a non-load bearing ceiling. It looks and feels like a small elevator but costs much less....
-
M305.3.2.2 Vertical Position
The height of the lowest end of the gripping surface on vertical standing supports shall be 34 inches (865 mm) minimum and 37 inches (940 mm) maximum above the standing surface....
-
Figure 307.4 Vertical Clearance – Drawing from the U.S. Access Board
-
2.3 Restrooms
Are there grab bars beside and behind the toilet?...
-
M305.3.2 Vertical Position
Where the support is vertical, it shall be 18 inches (455 mm) minimum in length and the bottom end of the support shall be 34 inches (865 mm) high minimum and 37 inches (940 mm) high maximum...
-
503.5 Vertical Clearance
pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger loading zone, and from the passenger loading zone to a vehicular exit shall provide a vertical...
-
Garaventa Genesis Shaftway - Vertical Platform Lift
The Genesis Shaftway model is a vertical platform wheelchair lift. This style lift has a capacity or 340 kg (750lbs.) and can provide access up to 4343mm (171")....
-
5.4 Dining Areas
In non-elevator buildings, an accessible means of vertical access to the mezzanine is not required under the following conditions: 1) the area of mezzanine seating measures no more than...
-
503.5 Vertical Clearance
pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger loading zone, and from the passenger loading zone to a vehicular exit shall provide a vertical...
-
11B-503.5 Vertical clearance
pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger loading zone and from the passenger loading zone to a vehicular exit shall provide a vertical...
-
Harmar RPL Residential Vertical Platform Lift
Harmar’s Residential Vertical Platform Lift (RPL) is a safe, smooth and economical solution to the barriers porches, staircases, decks and other elevation changes can create in and around...
-
Harmar EPL Enclosed Vertical Platform Lift
This self-contained Enclosed Platform is built to Harmar's exacting VPL standards with powder coated steel enclosure panels, providing vertical access indoors or out, with up to a 14’ rise...
-
Is vertical access required to all levels of a parking garage?
Vertical access must be provided as necessary to address any changes in level along these required accessible routes....
-
407.8.2 Side Reach
The vertical reference plane shall be centered on the operable part and placed at the leading edge of the maximum protrusion of the ICT within the length of the vertical reference plane....
-
407.12.2 Side Reach
The vertical reference plane shall be centered on the operable part and placed at the leading edge of the maximum protrusion of the ICT within the length of the vertical reference plane....
-
407.8.2.2 Obstructed Side Reach
Where the operable part is located more than 10 inches (255 mm), but not more than 24 inches (610 mm), beyond the vertical reference plane, the height of the operable part shall be 46 inches...
-
407.12.2.2 Obstructed Side Reach
Where the operable part is located more than 10 inches (255 mm), but not more than 24 inches (610 mm), beyond the vertical reference plane, the height of the operable part shall be 46 inches...
