A clear floor or ground space 60 inches (1525 mm) minimum by 96 inches (2440 mm) minimum shall be provided within weather shelters....
Search Results "Clear Tread Width"
Filters
Commonly Searched Documents
-
Weather Shelters: ADA Standard Section 1006.4
-
11B-1006.4 Weather shelters
A clear floor or ground space 60 inches (1524 mm) minimum by 96 inches (2438 mm) minimum shall be provided within weather shelters....
-
11B-305.7 Maneuvering clearance
Where a clear floor or ground space is located in an alcove or otherwise confined on all or part of three sides, additional maneuvering clearance shall be provided in accordance with Sections...
-
5.1.6 Clear Floor or Ground Space
A clear floor or ground space at least 36 inches (915 mm) by 48 inches (1220 mm) shall be provided parallel at the elevated entrance to the camp shelter....
-
Figure 305.5 Position of Clear Floor or Ground Space – Drawing from the U.S. Access Board
-
811.2 Clear Floor or Ground Space
811.2 Clear Floor or Ground Space. A clear floor or ground space complying with 305 shall be provided....
-
American Safety Tread Co., Inc. Type G500R Stairway Nosing Replacement
Width: 9" Lip: 1-3/8" at 90° angle Thickness: 1/4" Anchor Options: Drilled for screws....
-
American Safety Tread Co., Inc. Type SG4702 Stairway Nosing Replacement
Width: 5" Lip: 1-3/8" at 83° angle Thickness: 1/4" Anchor Options: Drilled for screws....
-
7.4.7 Openings
Openings in trail tread surfaces, trail resting spaces, and trail passing spaces shall be small enough to prevent passage of a 1/2 inch- (13 mm-) diameter sphere....
-
Width [4.7.3] and Surface [4.7.4]
The minimum clear width of a curb ramp is 36 inches, exclusive of flared sides....
-
Accessible Room Set-Up
Accessible Room Set-Up Once an accessible site is selected, it is essential that the meeting room furniture be arranged to allow everyone to fully participate. An accessible floor...
-
Accessible Routes (Exterior and Interior)
Once a voter with a disability arrives at the polling site, there must be an accessible route from the accessible parking, passenger drop-off sites, sidewalks and walkways, and...
-
403.5 Clearances
Walking surfaces shall provide clearances complying with 403.5. EXCEPTION: Within employee work areas, clearances on common use circulation paths shall be permitted to be...
-
403.5 Clearances
Walking surfaces shall provide clearances complying with 403.5. EXCEPTION: Within employee work areas, clearances on common use circulation paths shall be permitted to be...
-
Accessible Routes - Interior and Exterior
Accessible Routes - Interior and Exterior Common Problem: Both the exterior pedestrian routes (e.g., sidewalks, walkways and plazas) on a site that people use to travel from...
-
11B-603.2.3 Door swing
Doors shall not swing into the clear floor space or clearance required for any fixture....
-
Clear space
Clear space: A grid 72 inches long by 90 inches wide was used to facilitate the recording of space requirements for each WMD user (Figure 1)....
-
11B-502.2 Vehicle spaces
Car parking spaces shall be 108 inches (2743 mm) wide minimum and van parking spaces shall be 144 inches (3658 mm) wide minimum, shall be marked to define the width, and shall have an adjacent...
-
4.1.4 Clear Floor or Ground Space
At least 48 inches (1220 mm) of clear floor or ground space shall surround the usable sides of a picnic table, measured from the back edge of the benches....
-
11B-206.5.3 Transient lodging facilities
passage into and within guest rooms that are not required to provide mobility features complying with Section 11B-806.2 shall comply with Section 11B-404.2.3 _|Doors, Doorways, and Gates; Clear...
-
Obstacles [1018.5]
Changes in the vertical alignment of boards or the connection points for removable sections of beach access routes can be obstacles to beach access. When beach access routes are...
-
1018.5 Obstacles
This section contains technical requirements for obstacles on beach access routes and resting intervals. The vertical alignment of boards on a beach access route or removable...
-
Surfaces of Trails
Trail surfaces must be firm and stable. The first general exception allows achieving firmness and stability to the extent practicable if a condition for an exception prohibits full...
