Detectable warnings at parallel curb ramps shall be located so the edge nearest the curb is 6 inches (152 mm) minimum and 8 inches (203 mm) maximum from the demarcation line at the face...
Search Results "Boarding Ramp"
-
11B-705.1.2.2.2 Parallel curb ramps
-
Costs to Provide Detectable Warning Surfaces on Curb Ramps (Section-by-Section Analysis)
Costs to Provide Detectable Warning Surfaces on Curb Ramps (Section-by-Section Analysis) Detectable warning surfaces are available in a variety of materials....
-
Where must curb ramps be provided?
Generally, curb ramps are needed wherever a sidewalk or other pedestrian walkway crosses a curb....
-
505.10.1 Top and Bottom Extension at Ramps
Ramp handrails shall extend horizontally above the landing for 12 inches (305 mm) minimum beyond the top and bottom of ramp runs....
-
Temporary Solutions For Emergency Sheltering - Ramps
Problem: The accessible route crosses a curb but no curb ramp is provided. Suggestion: Install a portable ramp with a slope no steeper than 1:12 with edge protection....
-
11B-406.2.1 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
11B-406.2.1 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
11B-406.2.1 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
ADA & Level Boarding - Perfromance [sic] Standards on Station-by-Station Basis
49 CFR §37.42(d)(2) DECEMBER 14, 2011
-
§ 38.125(a)(2) Exception
If level-entry boarding, portable or platform lifts, ramps or bridge plates meeting the applicable requirements of this section are provided on station platforms or other stops required...
-
505.10.1 Top and Bottom Extension at Ramps
Ramp handrails shall extend horizontally above the landing for 12 inches (305 mm) minimum beyond the top and bottom of ramp runs....
-
505.10.1 Top and Bottom Extension at Ramps
Ramp handrails shall extend horizontally above the landing for 12 inches (305 mm) minimum beyond the top and bottom of ramp runs....
-
405.2 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
405.2 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
405.2 Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
§ 38.73(d)(1) Requirements
The design of level-entry vehicles shall be coordinated with the boarding platform or mini-high platform design so that the horizontal gap between a vehicle at rest and the platform shall...
-
General: ADA Standard Section 505.1
Section 505.1 of the ADA Standards covers information in the current ADA Standards for handrails.
-
Armor-Tile Tactile Systems Surface Applied Systems
adhesive, fasteners, sealant beveled edges for smooth transition meeting ADA requirements light weight and easy to handle easily cut to conform to angled and radius ramps...
-
1 [§ 4.7.3]
1 [§ 4.7.3] Only measure the width of the ramp section of the curb ramp (labeled “ramp” to the right [below]). The ramp section of a curb ramp is also known as the “ramp run.”...
-
Armor-Tile Tactile Systems Modular Paver Systems
be dry laid on compacted fill or set in a grout bed or drypac sustains dynamic vehicle loading, AASHTO HS20-44 wheel load test easily cut to conform to angled and radius ramps...
-
11B-705.2 Detectable directional texture
Detectable directional texture at transit boarding platforms shall comply with Figure 11B-705.2 and shall be 0.1 inch (2.5 mm) in height that tapers off to 0.04 inch (1.0 mm), with bars...
-
Clear Width [4.8.3]
The minimum dear width for ramps of 36 inches is measured between the leading edge of handrails. A maximum clear width is not specified....
-
11B-505.10 Handrail extensions
Handrail gripping surfaces shall extend beyond and in the same direction of stair flights and ramp runs in accordance with Section 11B-505.10. Exceptions: 1. ...
-
11B-505.10 Handrail extensions
Handrail gripping surfaces shall extend beyond and in the same direction of stair flights and ramp runs in accordance with Section 11B-505.10. Exceptions: 1. ...
