spaces or areas are equipped throughout with an automatic fire alarm system and are separated from the remainder of the building by a wall with a fire-resistance rating of not less than 1...
Search Results "Grade 1 Braille"
Commonly Searched Documents
-
903.3.1.1.1 Exempt locations
-
105.2.5 NFPA
Copies of the referenced standards may be obtained from the National Fire Protection Association, 1 Batterymarch Park, Quincy, Massachusetts 02169-7471, (http://www.nfpa.org)....
-
Responsibilities of Employees other than the CRO
[Sec. 382.61(a)(1)] These employees must receive training regarding awareness about and appropriate responses to individuals with physical, sensory, mental, and emotional disabilities....
-
Wheelchairs
[Sec. 382.41(e)(1)] • If the aircraft contains a closet or storage area of a size sufficient to accommodate a passenger’s folding, collapsible, or breakdown wheelchair, the carrier must...
-
205.1 General
EXCEPTIONS: 1. Operable parts that are intended for use only by service or maintenance personnel shall not be required to comply with 309. 2....
-
11B-405.5 Clear width
Exceptions: 1. ...
-
T503 Passenger Access Routes
.”), 1192.159(a)(1) (establishing same requirement for OTRBs)....
-
Managed Use
A mode of travel that is actively managed and appropriate on a trail, based on its design and management. 1....
-
Documenting Exceptions and Notifying the U.S. Access Board About Exemptions
Access Board About Exemptions When a condition for an exception prohibits full compliance with a specific technical requirement on a section of trail as allowed in General Exception 1, document...
-
Typical Issues
Accessible Passenger Drop-off and Loading Area Notes: 1. Access aisle depth is at least 5 feet. 2. Access aisle length is at least 20 feet. 3....
-
A4.2.1(3) Space Requirements for Passing
Able-bodied persons in winter clothing, walking straight ahead with arms swinging, need 32 in (815 mm) of width, which includes 2 in (50 mm) on either side for sway, and another 1 in (25...
-
A4.2.1(3) Space Requirements for Passing
Able-bodied people in winter clothing, walking straight ahead with arms swinging, need 32 in (815 mm) of width, which includes 2 in (50 mm) on either side for sway, and another 1 in (25...
-
1.1 Conditions for an Exception
Condition for an Exception 1. Where compliance with the technical provision is not practicable due to terrain. Condition for an Exception 2....
-
§1630.2(j)(3)(iii)
(iii) For example, applying the principles set forth in paragraphs (j)(1)(i) through (ix) of this section, it should easily be concluded that the following types of impairments will, at...
-
Model Building Codes and Industry Standards
The IBC contains application and scoping provisions for accessibility (in chapters 10, 11 and 34) that correspond to those in the ADA guidelines (chapters 1 and 2)....
-
1.1.14 Flatness of ramp cross slope
In addition to the measurement locations in 1.1.14, if a portion of the ramp appears to be steeper than 1:48 (approximately 2%) measure at that location as well....
-
Paragraph (b) (Advisory Guidance)
Paragraph (b) Connection Point for External Audio Processing Devices 1....
-
1193.33(b) (Advisory Guidance)
Paragraph (b) 1....
-
Paragraph (e) (Advisory Guidance)
Paragraph (e) TTY Signal Compatibility 1....
-
Certification of Equivalent Service
Such service, when viewed in its entirety, is provided in the most integrated setting feasible and is equivalent with respect to: (1) Response time; (2) Fares; (3) Geographic service...
-
11B-903.4 Back support
Back support shall be 2 1/2 inches maximum from the rear edge of the seat measured horizontally. [2010 ADAS] Advisory 903.4 Back Support....
-
[A] 111.2 Certificate issued
ETA Editor's Note The remainder of California Building Code Chapter 1, is not adopted by the Division of the State Architect - Access Compliance (DSA-AC), has been omitted....
-
II-2.1000 General
Title II protects three categories of individuals with disabilities: 1) Individuals who have a physical or mental impairment that substantially limits one or more major life activities...
-
11B-903.4 Back support
Back support shall be 2 1/2 inches maximum from the rear edge of the seat measured horizontally. Advisory 11B-903.4 Back support....