More information can be found in David Ballast’s book mentioned above and in the Access Board’s research study at http://www.access-board.gov/research/completed-research/dimensional-tolerances...
Search Results "ASCII: American Standard Code for Information Interexchange"
-
Q5.) What dimensions and conditions can practitioners reasonably consider to be compliant when the conditions, as constructed, do not meet the technical requirements exactly and there are no official, published, industry-developed tolerances?
-
Dispersion
Marina operators may choose to make information regarding accessible boat slips available in promotional material or a facility guide....
-
Visual Busyness (slide 13)
All of a sudden the place is so busy that you’re trying to take in too much information. And if it’s hard to see, it takes you a long time to take in all that information....
-
THREATS AND HAZARDS: WHAT CAN YOUR COMMUNITY DO?
COMMUNICATE EMERGENCY INFORMATION: notify your community about what is going on; spread the word about proper precautions and available resources....
-
Obligations of the Department
In order to assist the Board with its obligations under the ADA, the Department has provided the Board with information from the Department's March and November 2016 reviews of the...
-
Vision Impairments
Screen reading software reads the information on the screen in a certain order that is usually controlled by how the document was designed....
-
Height
The minimum height is consistent with the information provided by Midmark Corporation on examination table side rails, and the maximum height is generally consistent with the height of grab...
-
Title II Public Entity Facilities Compliance Fact Sheet
Alterations: Alterations to facilities of a public entity must also meet the "readily accessible" standard, to the maximum extent feasible....
-
Accessible Routes to Press Boxes
The 1991 Standards, at sections 4.1.1(1) and 4.1.3(1), cover all areas of newly constructed facilities required to be accessible, and require an accessible route to connect accessible entrances...
-
G. What are Detectable Warnings, Why are They Required, and Where Must They be Provided?
The ADA Standards require that curb ramps include features called “detectable warnings.”...
-
Alterations to Primary Function Areas
202.4 restates a current requirement under title III, and therefore represents no change for title III facilities or for those title II facilities that have elected to comply with the 1991 Standards...
-
M101.3 Existing Diagnostic Equipment (Section-by-Section Analysis)
The MDE NPRM did not address when or how the MDE Standards would be applied to existing medical diagnostic equipment....
-
§8.29 Homeownership programs (sections 235(i) and 235(j), Turnkey III and Indian housing mutual self-help programs).
If accessibility features selected at the option of the homebuyer are ones covered by the standards prescribed by §8.32, those features shall comply with the standards prescribed in §8.32...
-
Education's Enforcement of DOJ's Title II Regulations
For new construction and alterations commenced on or after March 15, 2012, the 2010 Title II ADA Standards will be used by Education in its enforcement of the Title II regulations.[28]...
-
3.3.12 180-Degree Turn around a Barrier
If the barrier is less than 1220 mm (48 in.) wide, the standard calls for a minimum passage width of 1065 mm (42 in.) and a minimum turn-around space depth of 1220 mm (48 in.)....
-
Application [§201]
Application [§201] The ADA Standards apply to the various types of facilities subject to the ADA, from simple structures to complex, multi-building sites such as university campuses and...
-
10 - foot straightedge method
However, there is no standardized protocol to measure deviations in lengths less than ten feet. The same problem exists when measuring slope....
-
M101.5 Dimensions
The MDE Standards are based on adult dimensions and anthropometrics. Dimensions that are not stated as “maximum” or “minimum” are absolute....
-
407.4.6.3 Keypads
Car control keypads shall be in a standard telephone keypad arrangement and shall comply with 407.4.7.2....
-
i.
"Suspicious Minds" Exhibit ramp leading to the exhibits; and See Standards § 4.8.5(3)....
-
407.4.6.3 Keypads
Car control keypads shall be in a standard telephone keypad arrangement and shall comply with 407.4.7.2....
-
225(d)(1)(B)
(B) establish minimum standards that shall be met in carrying out subsection (c) of this section;...
-
Station platforms
(DOT ADA Standard 810.5.3.)...
-
M18
[ADA Standards § 4.16.5] Yes No...