The Access Board worked closely with the FDA-CDRH in developing the proposed standards....
Search Results "Employee Work Area"
Commonly Searched Documents
-
Other relevant federal rules and guidance documents
-
Section 35.133 Maintenance of accessible features. (Section-by-Section Analysis)
(Section-by-Section Analysis) Section 35.133 in the 1991 title II regulation provides that a public entity must maintain in operable working condition those features of facilities and...
-
Alerting to intruders. (Section-by-Section Analysis)
The phrase ‘‘alerting to intruders'' is related to the issues of minimal protection and the work or tasks an animal may perform to meet the definition of a service animal....
-
Accessible Entrance
It is best to grade the area that is adjacent to the ramp to avoid an abrupt drop-off. If a drop-off exists, then a barrier such as a raised edge or railing must be installed....
-
Installation
Other deficiencies for PIP were cited in areas where the granules from the top layer began flaking off within the first three years of installation. ...
- Paraquad
- WFDB - The World Federation of the Deafblind
-
Alterations to cells. (Section-by-Section Analysis)
One large advocacy group stated that Option II was acceptable, stressing that program access requires the same training and work opportunities that other prisoners have. ...
-
1. INTRODUCTION
Transportation Barriers Compliance Board (the "Access" board) in their ruling that effective January 6th l981 all federally funded facilities must include listening systems in assembly areas...
-
Two-tiered definitional approach. (Section-by-Section Analysis)
mobility devices will mean that other power-driven mobility devices, specifically ATVs and off-highway vehicles, must be allowed to go anywhere on national park lands, trails, recreational areas...
-
III. Results of the Study
The success is largely because of the type of material we are fortunate to work with. However, the use geotextile is imperative to the trails lasting stability as well....
-
Seating Locations
Seating Locations: Set up the meeting room to provide access to all participant seating locations, the speakers' area, and refreshments....
-
11B-806.2.4 Toilet and bathing facilities
Toilet and bathing fixtures required to comply with Sections 11B-603 through 11B-610 shall be permitted to be located in more than one toilet or bathing area, provided that travel between...
-
13 [§ 4.7.10]
Therefore, if a marked crossing or crosswalk is provided, there must be a 48-inch deep area contained within the markings at the bottom of the ramp to protect people after they descend the...
-
General Issues
A new chapter was added through the incorporation of guidelines for recreation facilities and play areas that the Board previously finalized in separate rulemakings....
-
1012.2 Height
The height in assembly seating areas shall be in accordance with Section 1024.14....
-
§8.22(c)
(c) HUD may prescribe a higher percentage or number than that prescribed in paragraph (b) of this section for any area upon request therefor by any affected recipient or by any State or...
-
11B-503.5 Vertical clearance
The minimum vertical clearance at designated passenger drop-off and loading zones, and along at least one vehicle access route to the area from site entrances and exits, is 114 inches....
-
Protruding Objects [4.4]
The touch technique involves arcing the cane side-to-side to detect points beyond both shoulders and is often used in uncontrolled areas....
-
A4.16.5 Flush Controls
flush controls for flush valves to be located in a position that conflicts with the location of the rear grab bar, then that bar may be split or shifted toward the wide side of the toilet area...
-
Applying the Forest Service Outdoor Recreation Accessibility Guidelines
Section 1.0 "Application" states that newly constructed and altered camping facilities, picnic areas, constructed features, beach access routes, and outdoor recreation access routes under...
-
C2-1. Objects on sidewalks
Are all sidewalks and walkways to the voting area free of any objects (e.g., wall-mounted boxes, signs, handrail extensions, trees) with bottom edges that are higher than 27 inches but less...
-
A4.16.5 FLUSH CONTROLS
flush controls for flush valves to be located in a position that conflicts with the location of the rear grab bar, then that bar may be split or shifted toward the wide side of the toilet area...