Spaces frequented only by service personnel for maintenance, repair, or occasional monitoring of equipment shall not be required to comply with these requirements or to be on an accessible...
Search Results "Comply With"
Filters
Commonly Searched Documents
-
11B-203.5 Machinery spaces
-
11B-239.2 Minimum number
At least 50 percent of holes on miniature golf courses shall comply with Section 11B-1007.3. Advisory 11B-239.2 Minimum number....
-
11B-1008.2.6 Ground surfaces
Ground surfaces on accessible routes, clear floor or ground spaces, and turning spaces shall comply with Section 11B-1008.2.6. Advisory 11B-1008.2.6 Ground surfaces....
-
11B-404.3.6 Break out opening
Exception: Where manual swinging doors and gates comply with Section 11B-404.2 and serve the same means of egress compliance with Section 11B-404.3.6 shall not be required....
-
11B-604.3.1 Size
Exception: In residential dwelling units complying with Section 11B-233.3.1.1, maneuvering space in front of the water closet shall be a minimum 60 inches (1524 mm) wide and 36 inches (914...
-
11B-504.5 Nosings
While Chapter 10 may allow larger radius of curvature at the leading edge (nosing) of the tread, this radius must be no larger than ½ inch to comply with both Chapter 10 and Chapter 11B...
-
11B-809.10.5.2 Reinforcement for grab bars
Reinforcement for grabs bars shall comply with the following: 1....
-
104.11 Alternative materials, design and methods of construction and equipment
An alternative material, design or method of construction shall be approved where the building official finds that the proposed design is satisfactory and complies with the intent of the...
-
Passing Spaces [1017.4]
Where the full length of a trail does not fully comply with the trail technical requirements, a passing space must be located at the end of the trail segment that complies fully with the...
-
Trailhead Information Signs [F216.13 and 1017.10]
This requirement applies to new trailhead information signs regardless of whether the newly constructed or altered trail complies with the technical requirements for trails....
-
III-6.1000 General
The new floor must comply with, for example, ADAAG requirements for a nonslip surface or with the ADAAG carpeting requirements, if applicable....
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
Residential dwelling units shall comply with Section 11B-233.3.4.2. 2....
-
New Construction and Alterations
If the last or final building permit application for a new construction or alterations project is certified before March 15, 2012, businesses may comply with either the 1991 or the 2010...
-
3. Modified Theaters
The modifications that Cinemark will make to the Modified Theaters pursuant to this Consent Order will be completed such that the changes made to comply with the provisions of Paragraph...
-
11B-221.2.1.3 Other boxes
In boxes other than those required to comply with Section 11B-221.2.1.2, the total number of wheelchair spaces required shall be determined in accordance with Table 11B-221.2.1.1....
-
F222.1 General
Where dressing rooms, fitting rooms, or locker rooms are provided, at least 5 percent, but no fewer than one, of each type of use in each cluster provided shall comply with 803....
-
M302.3.1 Transfer Supports (Section-by-Section Analysis)
Board proposed that transfer supports must be provided for use with transfer sides on diagnostic equipment used by patients in the seated position, and that these transfer supports must comply...
-
F206.2.5 Restaurants and Cafeterias
In sports facilities, tiered dining areas providing seating required to comply with F221 shall be required to have accessible routes serving at least 25 percent of the dining area provided...
-
222.1 General
Where dressing rooms, fitting rooms, or locker rooms are provided, at least 5 percent, but no fewer than one, of each type of use in each cluster provided shall comply with 803....
-
F240.1.1 Additions
Where play areas are designed and constructed in phases, the requirements of F240 shall apply to each successive addition so that when the addition is completed, the entire play area complies...
-
208.2 Minimum Number
Parking spaces complying with 502 shall be provided in accordance with Table 208.2 except as required by 208.2.1, 208.2.2, and 208.2.3....
-
233.3.4.2 Alterations to Individual Residential Dwelling Units
altered, and at least one other room is altered, the requirements of 233.3.1 shall apply to the altered residential dwelling units until the total number of residential dwelling units complies...
-
240.1.1 Additions
Where play areas are designed and constructed in phases, the requirements of 240 shall apply to each successive addition so that when the addition is completed, the entire play area complies...
-
T210 Wheelchair Spaces
Wheelchair spaces must also be located as near as practicable to doorways that provide accessible boarding and alighting features and comply with the technical requirements in T602....