Search Results "Accessibility Guideline"
Filters
Commonly Searched Documents
-
Figure 608.3.2 Grab Bars for Standard Roll-In Type Showers – Drawing from the U.S. Access Board
-
Figure 608.2.1 Transfer Type Shower Compartment Size and Clearance – Drawing from the U.S. Access Board
-
Figure 404.2.4.3(c) Maneuvering Clearance at Recessed Doors and Gates – Drawing from the U.S. Access Board
-
Figure 404.2.4.3(b) Maneuvering Clearance at Recessed Doors and Gates – Drawing from the U.S. Access Board
-
Figure 406.2 Counter Slope of Surface Adjacent to Curb Ramps – Drawing from the U.S. Access Board
-
Figure 609.2.2 Grab Bar Non-Circular Cross Section – Drawing from the U.S. Access Board
-
Figure 608.3.3 Grab Bars for Alternate Roll-In Type Showers – Drawing from the U.S. Access Board
-
Figure 1003.3.1 (Exception 2) Edge Protection at Boat Slips – Drawing from the U.S. Access Board
-
Figure 608.5.1 Transfer Type Shower Compartment Control Location – Drawing from the U.S. Access Board
-
11B-104.1.1 Construction and manufacturing tolerances
Specifying dimensions in design in the manner described above will better ensure that facilities and elements accomplish the level of accessibility intended by these requirements....
-
Tactile Surface
recommended that these provisions were unnecessary in view of the general provision for equivalent facilitation in section 103 permitting departures from this or any other requirement in the guidelines...
-
Shower Spray Unit
The guidelines require tubs to have shower spray units that can be used as both a fixed position shower head and a hand-held shower (607.6)....
-
1. Rulemaking History Prior to the 2010 ANPRM
of updating the 1991 title II and title III regulations to adopt revised ADA Standards based on the relevant parts of the 2004 Americans with Disabilities and Architectural Barriers Act Accessibility...
-
Platform Lifts
Comments suggested that the guidelines use the industry term "platform lifts" instead of "wheelchair (platform) lifts."...
-
A. Final Regulatory Assessment (EO 12866)
The Access Board prepared a final regulatory impact analysis (Final RA) that assesses the likely benefits and costs of the 2016 Non-Rail Vehicle Guidelines....
-
I. Slip Resistant Surface—Aisles, Steps, Floor Areas Where People Walk, Floor Areas in Securement Locations, Lift Platforms, Ramps
A research project sponsored by the Architectural and Transportation Barriers Compliance Board (Access Board) conducted tests with persons with disabilities and concluded that a higher coefficient...
-
Background
US Access Board....
-
M302.2.3 Size (Section-by-Section Analysis)
The Access Board also solicited comment in question 16 on whether the transfer surface size proposed for seated position diagnostic equipment was sufficient to facilitate independent transfer...
-
Acceptable Trail Surfacing Requirements
The Americans with Disabilities Act (ADA 1990) states that accessible surfaces shall be stable, firm, and slip-resistant....
-
Center for Inclusive Design and Environmental Access (IDeA Center)
The IDeA Center is dedicated to making environments and products more usable, safer and healthier in response to the needs of an increasingly diverse population. The IDeA Center’s...
-
1. GENERAL
This attachment describes the manner in which facilities designed, constructed (including additions), altered, leased, or funded by the Department of Defense (DoD) are to be made accessible...
-
a. Structural Strength
The Access Board sought input in question 18, on whether current transfer supports are capable of resisting vertical and horizontal forces of 250 pounds at all points....
-
(3) Adjustability: Transfer Surface Intermediate Heights
In addition to the matter of low transfer height, the Access Board sought public comment in question 14(c) on whether the final rule should require intermediate heights between a minimum...
-
Pilot Rock WXT and WXTH Picnic Table Using Aluminum
Series Overview Model WXT and WXTH Picnic Tables are ADA Compliant and accessible to wheelchairs at both ends. ...
