professional grade penetrating sealer designed for the slip-protection of all ceramic tile, porcelain tile, polished marble, polished granite, concrete, masonry and other acid sensitive surfaces...
Search Results "Walking Surface"
Filters
Commonly Searched Documents
-
Miracle Sealant Slip-Resistant Flooring Treatment
-
Part I. A Longitudinal Study of Trail Surfaces Final Report
A Longitudinal Study of Trail Surfaces Final Report...
-
Part II. National Trail Surface Survey Final Report
National Trail Surface Survey Final Report...
-
Installation of Test Surfaces
Installation of Test Surfaces In accordance with standard EWF design and construction practice (Figure 2), the full depth surfaces were prepared to the same requirements needed for permanent...
-
Installation of Aggregate Surfaces at Bradford Woods
Installation of Aggregate Surfaces at Bradford Woods The installation of the aggregate surfaces at Bradford Woods conformed to the following protocol: Prior to installing the crushed...
-
11B-405.3 Cross slope
Cross slope is the slope of the surface perpendicular to the direction of travel....
-
1014.3 Floor
This section requires the floor surface within camp shelters to be firm and stable and to slope not steeper than 1:48 in any direction....
-
R302.7 Surfaces
R302.7 Surfaces....
-
11B-305.2 Floor or ground surfaces
Floor or ground surfaces of a clear floor or ground space shall comply with Section 11B-302....
-
409.4.2 Floor Surfaces
Floor surfaces in elevator cars shall comply with 302 and 303....
-
409.4.2 Floor Surfaces
Floor surfaces in elevator cars shall comply with 302 and 303....
-
M301.2 Transfer Surface (Section-by-Section Analysis)
This is an introductory section.
-
11B-306.2.3 Minimum required depth
The toe clearance shall extend 19 inches (483 mm) minimum under built-in dining and work surfaces required to be accessible by Section 11B-226.1....
-
11B-405.4 Floor or ground surfaces
Floor or ground surfaces of ramp runs shall comply with Section 11B-302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
11B-405.4 Floor or ground surfaces
Floor or ground surfaces of ramp runs shall comply with Section 11B-302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
11B-405.4 Floor or ground surfaces
Floor or ground surfaces of ramp runs shall comply with Section 11B-302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
Problem One (Accessible Route)
Problem One: The sidewalk connecting parking to the polling place entrance is too steep to be accessible. Solution: Check to see if there is another sidewalk that provides an...
-
Problem Four (Accessible Route)
Problem Four: The interior hallway leading to the voting area contains a set of stairs that cannot be ramped. Solution: If the accessible route cannot be relocated, look for...
-
C2‒1
C2‒1. Are all sidewalks and walkways to the shelter free of any objects (e.g., wall-mounted boxes, signs, handrail extensions) with bottom edges that are between 27 inches and 80...
-
C1-3. Accessible Route Width
C1-3. Is the accessible route at least 36 inches wide? If No, the accessible route may narrow to 32 inches wide for up to 2 feet in length. Yes _____ No _____
-
C1-1. Accessible Route
C1-1. Is an accessible route provided from accessible parking spaces to the accessible entrance of the building? [ADA Stds 4.1.2(1), 4.3] Yes _____ No _____ Note: If the...
-
C1-2. Accessible Route
C1-2. Is an accessible route provided from public sidewalks and public transportation stops on the polling site (if provided) to the accessible entrance of the building? [ADA Stds...
-
C1-4. Accessible Route Level Changes
C1-4. Is the accessible route free of steps and abrupt level changes over 1/2 inch? Note: Level changes between 1/4 inch and 1/2 inch should be beveled. Yes _____ No _____