The height of transfer device seats shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
Search Results "Transfer Surface"
-
1002.6.2 Transfer Height
-
Dispersion: ADA Standard Section 226.2
Section 226.2 covers scoping requirements in the current ADA Standards for dispersion of dining surfaces and work surfaces.
-
Surface discontinuities
Differences in level between two adjacent surfaces. Elevation changes due to ramps or stairs do not, themselves, constitute surface discontinuities....
-
5.3.2.2 Surface
The surface of the turning space and clear floor or ground space shall be firm and stable....
-
1012.4 Surface
This section requires the surface of parking spaces and pull-up spaces to be firm and stable....
-
R409.8 Surfaces
R409.8 Surfaces. Handrail gripping surfaces and any surfaces adjacent to them shall be free of sharp or abrasive elements and shall have rounded edges....
-
PlayLSI Tree Stump Transfer Module
Model Number: #173585 Age Range: 2 to 5 The Tree Stump Transfer Module is the perfect gateway to nature-inspired play....
-
TechniSoil G3® Commercial Surface Liquid Polymer Stabilizer
TechniSoil G3 Commercial Surface (G3-CS) is a commercial grade liquid polymer stabilizer for durable, dust-free surfaces using decomposed granite (DG) or crushed stone materials....
-
Figure 1009.5.2 Clear Deck Space at Transfer Platform – Drawing from the U.S. Access Board
-
T402.5 Surfaces
Ramp and bridgeplate surface material shall comply with T302 and extend across the full width and length of the ramp or bridgeplate....
-
11B-810.2.1 Surface
Bus stop boarding and alighting areas shall have a firm, stable surface....
-
11B-810.2.1 Surface
Bus stop boarding and alighting areas shall have a firm, stable surface....
-
11B-810.2.1 Surface
Bus stop boarding and alighting areas shall have a firm, stable surface....
-
Unitary Surface
Unitary Surfaces. The predominant surface characteristic is whole. ...
-
Technical Memorandum TM 2017-25 Door and Gate Surfaces
floor to have a smooth surface on the push side....
-
5.4.1 Transfer Support Location for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
5.4.1 Transfer Support Location for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position....
-
5.4.2 Transfer Support Length for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
5.4.2 Transfer Support Length for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position....
-
4.2.7 Surface
The surface of the clear floor or ground space shall be firm and stable. The type of surface should be appropriate to the setting and level of development....
-
226 Dining Surfaces and Work Surfaces
226 Dining Surfaces and Work Surfaces...
-
902 Dining Surfaces and Work Surfaces
902 Dining Surfaces and Work Surfaces...
-
F202.6.5.4 Dining Surfaces and Work Surfaces
Dining surfaces and work surfaces shall comply with F226....
-
M305.2.1 Location (Section-by-Section Analysis)
For transfer surface depths on tables less than 24 inches wide, a transfer support must be available on the side opposite the entry of the transfer surface… For transfer surface depths on...
-
(3) Transfers of Privately Held Equity Interests
(3) Transfers of Privately Held Equity Interests: A transfer of interest in a Brand Hotel in which, after conveyance of the interest, a 25% or more cumulative interest in the Brand Hotel...
-
5.3 Transfer Sides Recommendations
5.3 Transfer Sides Recommendations...
