Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance. [Safe Harbor only applies to existing primary entrances.]...
Search Results "Side Transfer Surface"
-
11B-404.2.4 Maneuvering clearances
-
Height: ADA Standard Section 505.4
Section 505.4 covers the current ADA Standards for the height of the top of the gripping surface of handrails.
-
What proportion of the population could negotiate these surfaces?
What proportion of the population could negotiate these surfaces?...
-
Side Reach [§308.3]
Side Reach [§308.3] The range for side reach, like forward reach is 15” to 48” if unobstructed....
-
Surface Textures [4.3.6]
In developing various outdoor environments, consultation with people with disabilities, including local groups and officials, can be helpful in determining acceptable designs and surface...
-
1132A.9 Smooth surface
1132A.9 Smooth surface. ...
-
11B-403.2 Floor or ground surface
Floor or ground surfaces shall comply with Section 11B-302....
-
11B-403.2 Floor or ground surface
Floor or ground surfaces shall comply with Section 11B-302....
-
11B-403.2 Floor or ground surface
Floor or ground surfaces shall comply with Section 11B-302....
-
Measuring Surface Firmness and Stability
The rotational penetrometer (RP) is a precision surface-indenter measuring tool for evaluating the firmness and stability of ground and floor surfaces (figure 1). ...
-
M302.3.1 Transfer Supports (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed that transfer supports must be provided for use with transfer sides on diagnostic equipment used by patients in the seated position, and that these...
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Slope: ADA Standard Section 403.3
Section 403.3 covers the current ADA Standards for the slope of walking surfaces that are part of an accessible route.
-
407.12.2 Side Reach (Section-by-Section Analysis)
407.12.2 Side Reach (Section-by-Section Analysis) This section specifies proposed requirements for operable parts providing unobstructed or obstructed side reaches....
-
11B-804.3.3 Exposed surfaces
There shall be no sharp or abrasive surfaces under the work surface counters....
-
11B-804.3.3 Exposed surfaces
There shall be no sharp or abrasive surfaces under the work surface counters....
-
11B-804.3.3 Exposed surfaces
There shall be no sharp or abrasive surfaces under the work surface counters....
-
11B-308.3.1 Unobstructed
Where a clear floor or ground space allows a parallel approach to an element and the side reach is unobstructed, the high side reach shall be 48 inches (1219 mm) maximum and the low side...
-
11B-308.3.1 Unobstructed
Where a clear floor or ground space allows a parallel approach to an element and the side reach is unobstructed, the high side reach shall be 48 inches (1219 mm) maximum and the low side...
-
R409.6 Gripping Surface
R409.6 Gripping Surface. Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
Surface Slopes
The final rule requires clear ground spaces to have slopes not steeper than 1:48 in any direction and, where the surface is other than concrete, asphalt, or boards, permits slopes not steeper...
-
1002.5.2 Transfer Height
1002.5.2 Transfer Height....
-
When Transfer Systems Are Used
When Transfer Systems Are Used A transfer system provides access to elevated play components within a composite system by connecting different levels with transfer platforms and steps...