Where seating is provided in saunas and steam rooms, at least one bench shall comply with Section 11B-903....
Search Results "Comply With"
Filters
Commonly Searched Documents
-
11B-612.2 Bench
-
M301.4 Lift Compatibility
Diagnostic equipment shall be usable with portable patient lifts and, when in use with such lifts, shall comply with M301.4.1 or M301.4.2....
-
407.2.3.2 Car Designations
Destination-oriented elevators shall provide tactile car identification complying with 703.2 on both jambs of the hoistway immediately below the floor designation....
-
M302.4 Lift Compatibility
Diagnostic equipment shall be usable with portable patient lifts and, when in use with such lifts, shall comply with M302.4.1 or M302.4.2. ...
-
SECTION 1008 DOORS, GATES AND TURNSTILES
egress from, buildings or facilities where accessibility is required for applications listed in Section 1.9.1 regulated by the Division of the State Architect—Access Compliance, shall also comply...
-
Dressing, Fitting, or Locker Rooms
Dressing, Fitting, or Locker Rooms When provided, dressing, fitting, or locker rooms must be accessible and comply with all ADAAG provisions....
-
405.9.1 Extended Floor or Ground Surface
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
F225.3.1 Dispersion
Self-service storage spaces complying with Table F225.3 shall not be required to be dispersed among buildings in a multi-building facility....
-
General (R302.1) (Section-by-Section Analysis)
In alterations where existing physical constraints make it impractical to fully comply with the technical requirements, compliance is required to the extent practicable within the scope...
-
225.3.1 Dispersion
Self-service storage spaces complying with Table 225.3 shall not be required to be dispersed among buildings in a multi-building facility....
-
T703.1 General
The International Symbol of Accessibility shall comply with Figure T703.1. The symbol shall have a background field height of 4 inches (100 mm) minimum....
-
If the lift manufacturer specifies that wheelchairs must face away from the vehicle when using the lift, are transportation operators required to permit passengers to board facing the vehicle?
A lift that requires passengers to face a specific direction does not comply with the regulations....
-
§ 36.105(d)(1)(ii)
(ii) The primary object of attention in cases brought under title III of the ADA should be whether public accommodations have complied with their obligations and whether discrimination has...
-
11B-230.1 General
Where a two-way communication system is provided to gain admittance to a building or facility or to restricted areas within a building or facility, the system shall comply with Section 11B...
-
504.4 Tread Surface
Stair treads shall comply with 302. Changes in level are not permitted. EXCEPTION: Treads shall be permitted to have a slope not steeper than 1:48....
-
10.3.1(4)
(4) Where signs are provided at entrances to stations identifying the station or the entrance, or both, at least one sign at each entrance shall comply with 4.30.4 and 4.30.6....
-
A7.2(3) Assistive Listening Devices
offices, and information kiosks where a physical barrier separates service personnel and customers, it is recommended that at least one permanently installed assistive listening device complying...
-
4.31.2 Clear Floor or Ground Space
The clear floor or ground space shall comply with 4.2.4. Bases, enclosures, and fixed seats shall not impede approaches to telephones by people who use wheelchairs....
-
R206 Pedestrian Street Crossings
Pedestrian street crossings shall comply with R306. Advisory R206 Pedestrian Street Crossings. All pedestrian street crossings must be accessible to pedestrians with disabilities....
-
404.2.7 Door and Gate Hardware
Handles, pulls, latches, locks, and other operable parts on doors and gates shall comply with 309.4....
-
4.1.1(2) Application Based on Building Use
When a building or facility contains more than one use covered by a special application section, each portion shall comply with the requirements for that use....
-
404.2.7 Door and Gate Hardware
Handles, pulls, latches, locks, and other operable parts on doors and gates shall comply with 309.4....
-
4.21.3 SEAT
The structural strength of seats and their attachments shall comply with 4.26.3....
-
State and Local Government Facilities
Units of government at the state, county, and local levels are subject to the ADA and must comply with the ADA Standards in new construction and alterations....