Exceptions Considered for Wheelchair Spaces on Raised Platforms M303.2.2 Proposed Exception: The exception to the minimum width in M303.2.2 would apply where ramped surfaces are provided...
Search Results "Hybrid Surface System"
Filters
Commonly Searched Documents
-
M303.2.3 Wheelchair Spaces / Depth of Wheelchair Spaces for front or Rear Entry
-
1. Thigh Breadth
Thigh Breadth Thigh breadth was used to provide an estimate of the width of the seating surface....
-
M304 Diagnostic Equipment Used by Patients in Standing Position
M304.2 and M304.3 would require a slip resistant standing surface and standing supports to accommodate patients with mobility disabilities who ambulate, patients who have limited stamina...
-
Bradley Diplomat Waste Receptacle 3A15-11
Diplomat Washroom Accessories designed with unique dual-curve geometry Diplomat Accessories Gallery Recess, semi-recess, or surface mounted options 16.5 gallon option...
-
Center for Independent Living of South Florida - Miami, FL
Our Mission Empowering people of all ages, with disabilities to reach their highest level of achievement; advocating for systems change that results in access, choice, equality, inclusion...
-
THREATS AND HAZARDS IN NEW YORK CITY
An earthquake is the sudden, rapid shaking of the ground caused by two blocks of earth slipping past each other beneath the surface....
-
11B-703.7.2.5 Cleaner Air Symbol
There shall be at least a 70-percent color contrast between the background of the sign from the surface that it is mounted on. FIGURE 11B-703.7.2.5 ‡‡ CLEANER AIR SYMBOL...
-
704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (865 mm) minimum above the finish floor....
-
Companion Seats
with the ANSI A117.1‒2003 standard, the provision in the final rule specifies that shoulder alignment is to be measured 36 inches from the front of the wheelchair space and that the floor surface...
-
Maneuvering Space
Objects are not permitted to protrude into ground level maneuvering spaces at or below 80 inches (2030 mm) above the ground or floor surface....
-
BENEFITS AND COSTS: OVERVIEW
BENEFITS AND COSTS: OVERVIEW Based on our analysis, we determined that transfer surface height requirements lower than 19 inches would increase the cost of designing and manufacturing...
-
QUESTION: WHAT LIMITATIONS CAN A PVO IMPOSE WITH RESPECT
TO CARRYING A SERVICE ANIMAL?
* For example, a PVO could impose a legitimate safety requirement that a service dog not be permitted to enter a sauna or steam room, sit on any surface other than the floor, or join...
-
604.7 Dispensers
paper dispensers are installed above the side wall grab bar, the outlet of the toilet paper dispenser must be 48 inches (1220 mm) maximum above the finish floor and the top of the gripping surface...
-
704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (865 mm) minimum above the finish floor....
-
R309.4 Curb Ramps or Blended Transitions
Detectable warning surfaces are not required on curb ramps and blended transitions that connect the access aisle to the sidewalk, including where the sidewalk is at the same level as the...
-
Parallel Parking Spaces (R309.2) (Section-by-Section Analysis)
The access aisle must not encroach on the vehicular travel lane and comply with the technical requirements for surfaces (see R302.7)....
-
704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (865 mm) minimum above the finish floor....
-
Platform Edges
Where this breakaway material is installed at a platform edge, the width of the detectable warning surface can begin at the edge of the breakaway material rather than at the edge of the...
-
Obstructions [4.7.8]
needed at the top and bottom of ramps so that people using wheelchairs can align with the running slope and maneuver from ramps, including when making turns (which is difficult on sloped surfaces...
-
Example of a Single-User Bathroom (with Roll-in Shower)
Recommendation: Consider providing turning space outside the shower so that people using wheelchairs do not have to travel on wet surfaces every time they use the room....
-
604.7 Dispensers
paper dispensers are installed above the side wall grab bar, the outlet of the toilet paper dispenser must be 48 inches (1220 mm) maximum above the finish floor and the top of the gripping surface...
-
Trailhead Signs
on newly constructed or altered trails designed for use by hikers or pedestrians, the final rule requires the signs to include information on the length of the trail or trail segment; surface...
-
1. Scope
statistic called the Pathway Roughness Index (PRI). 1.2 This provides a standard practice for computing and reporting an estimate of pathway roughness for sidewalks and other pedestrian surfaces...
-
The SmartWheel
The SmartWheel has been accepted as a measurement tool for the ASTM PS 83 - 97/F1951 Standard on Playground Surface Accessibility....
