Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance. Exception: Reserved....
Search Results "Access Aisle Width"
Commonly Searched Documents
-
11B-404.2.4 Maneuvering clearances
-
Passing Spaces on Trails
A 60-inch (1,525-millimeter) clear tread width is required for two wheelchairs to pass safely and comfortably on a trail....
-
Re: Single User Restroom Accessibility
I think Assembly Bill only relates to signage, not the accessibility, therefore, I would observe the plumbing code first and provide accessible restrooms then provide unisex signage....
-
5) Areas of rescue assistance or places of refuge
Specific requirements are provided for such features as location, size, stairway width, and two-way communications....
-
Revolving Doors or Turnstiles
A commenter advised that no revolving doors or turnstiles should be permitted on an accessible route. Response....
-
11B-703.5.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
11B-703.2.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
§382.117(b)
(b) You must permit the service animal to accompany the passenger with a disability at any seat in which the passenger sits, unless the animal obstructs an aisle or other area that must...
-
Section 36.302 Modifications in Policies, Practices, or Procedures (Preamble, Section-by-Section Analysis)
That paragraph provides that a store with check-out aisles must ensure that an adequate number of accessible check-out aisles is kept open during store hours, or must otherwise modify its...
-
Section 36.302 Modifications in Policies, Practices, or Procedures (Section-By-Section Analysis and Response to Comments)
That paragraph provides that a store with check-out aisles must ensure that an adequate number of accessible check-out aisles is kept open during store hours, or must otherwise modify its...
- American Trails Resources and Library: Accessible Trails
- National Center on Accessibility at Indiana University Bloomington
-
§100.205(e)(2)(iii) 2000 ICC Code Requirements for Housing Accessibility (CRHA)
(iii) 2000 ICC Code Requirements for Housing Accessibility (CRHA), published by the International Code Council (ICC), October 2000 (with corrections contained in ICC-issued errata sheet)...
- Rehabilitation Engineering Research Center on Accessible Public Transportation
- Tobii PCEye Go: Access Your Computer or Tablet Through Gaze Interaction Video
-
T302.3 Openings
Wheelchair securement system components affixed to walking surfaces shall be permitted to have openings 7/8 inch (22 mm) maximum in width provided that, where such openings are more than...
-
Wheelchair Spaces
Wheelchair spaces should not overlap required exit widths or circulation paths and should provide for shoulder-to-shoulder alignment with occupants of adjacent seats (an important consideration...
-
5.8.1 Wheelchair Spaces on Raised Platforms Recommendations
M303.2.2 Width. Wheelchair spaces shall be 36 inches wide minimum. M303.2.3 Depth....
-
ENSURING LANGUAGE ACCESS AND EFFECTIVE COMMUNICATION DURING RESPONSE AND RECOVERY: A CHECKLIST FOR EMERGENCY RESPONDERS
Title VI of the Civil Rights Act of 1964 and Section 504 of the Rehabilitation Act of 1973.1 These services may include providing language access services2 to provide meaningful access...
- Emergency Planning for People with Access and Functional Needs
-
11B-235.2 Boat slips
TABLE 11B-235.2 BOAT SLIPS TOTAL NUMBER OF BOAT SLIPS PROVIDED IN FACILITY MINIMUM NUMBER OF REQUIRED ACCESSIBLE BOAT SLIPS...
-
A4.13.9 Door Hardware
To be effective, they should cover the door width, less approximately 2 in (51 mm), up to a height of 16 in (405 mm) from its bottom edge and be centered across the width of the door....
-
11B-703.2.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
11B-703.5.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....