Where a clear space allows a parallel approach to an element and the side reach is unobstructed, the high side reach shall be 1220 mm (4.0 ft) maximum and the low side reach shall be 380...
Search Results "Parking Space Width"
-
R406.3 Unobstructed Side Reach
-
End-of-Row Stalls
End-of-Row Stalls The design of end-of-row stalls incorporates aisle space into the stall for easier maneuvering; consider this design even where a stall is not located at the end of...
-
4.7.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
Fraudulent purchase of designated accessible seating. (Section-by-Section Analysis)
The Department has received numerous comments regarding fraudulent attempts to purchase wheelchair spaces for patrons other than those who use wheelchairs. ...
-
Wheelchairs
aircraft contains a closet or storage area of a size sufficient to accommodate a passenger’s folding, collapsible, or breakdown wheelchair, the carrier must designate priority stowage space...
-
1118B.3
SECTION 1118B - SPACE ALLOWANCE AND REACH RANGES 1118B.3 Wheelchair turning space. ...
- Magnuson Group SLOPE Waste Receptacles
- Delta Single Handle Centerset Lavatory Faucet 515LF-HDF
- Tork Elevation® Liquid Soap Dispenser, Black
- SuperDeck Beach Boardwalk
- Inpro Corporation JointMaster® 101 Series Floor Expansion Joint Covers
- Inpro Corporation JointMaster® 103 Series-VCT Expansion Joint Systems
- SafePath EZCurb™ Wheelchair Ramps - Vertical Barrier Removal
-
Escalators
Escalators must have a clear width of 32 inches minimum (810.9)....
-
11B-1007.2 Accessible routes
Where accessible routes intersect playing surfaces of holes, a 1 inch (25 mm) maximum curb shall be permitted for a width of 32 inches (813 mm) minimum. 3. ...
-
404.2.10 Door and Gate Surfaces
Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
404.2.10 Door and Gate Surfaces
Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Recumbent Bicycles
Recumbents are generally longer and wider than upright bicycles, but they are available in many different shapes and sizes so length and operating width vary greatly....
-
11B-1007.2 Accessible routes
Where accessible routes intersect playing surfaces of holes, a 1 inch (25 mm) maximum curb shall be permitted for a width of 32 inches (813 mm) minimum. 3....
-
11B-406.6 Islands
The clear width of the accessible route at islands shall be 60 inches (1524 mm) wide minimum. Where curb ramps are provided, they shall comply with Section 11B-406....
-
T302 Walking Surfaces
To address this concern, an exception has been added to the final rule that allows a larger opening (7/8 inch width maximum) for wheelchair securement system components affixed to walking...
-
Polypavement
Upon drying up, the surface remained cracked and was heaving along the full width of the trail....
-
11B-306.3.1 General
Space under an element between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground shall be considered knee clearance and shall comply with Section 11B-306.3....
-
R310.3 Access Aisle
Passenger loading zones shall provide access aisles complying with R310.3 adjacent to the vehicle pull-up space....