[ECTCR UFAS 5.1] 2. ...
Search Results "Grade 2 Braille"
-
F206.2.5 Restaurants and Cafeterias
-
1115B.3.1, Item 5
… 2. … 3. … 4. … 5. Large toilet rooms. ...
-
Benches
If the bench is not located next to a wall, the bench must have back support that is 42 inches minimum in length and extends from a point 2 inches maximum above the seat to a point 18 inches...
-
224.6 Housing at a Place of Education
containing accessible sleeping rooms with mobility features shall provide turning spaces that comply with section 809.2.2 and kitchen work surfaces that comply with section 804.3. 2....
-
404.2.10 Door and Gate Surfaces
Sliding doors shall not be required to comply with 404.2.10. 2....
-
505.6 Gripping Surface
not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along their entire length where they are integral to crash rails or bumper guards. 2....
-
Transfer Access [1014.2.1]
When the surface of the clear ground space is constructed of asphalt, concrete, or boards, the slope of the clear ground space must be no steeper than 1:48 (2 percent) in any direction....
-
M305.2 Transfer Supports
Possible language as modified from IEC 60601-2-52: “Transfer Supports shall be designed to withstand the forces applied during reasonably foreseeable use without creating an unacceptable...
-
"Minimal protection." (Section-by-Section Analysis)
interpreted to allow "protection dogs" that are trained to be aggressive and to provide protection to be covered under the ADA, so long as they are paired with a person with a disability; and (2)...
-
School Districts' Standards and Procedures
. § 104.35(b)(2). 56 Id. 57 34 C.F.R. § 104.35(b)(3). 58 34 C.F.R. § 104.35(b)(1). 59 Id....
-
Primary Function
- Source: Definition from ADA Title III Regulations Alterations To An Area Containing A Primary Function: 4.1.6(2) In addition to the requirements of 4.1.6(1), an alteration that...
-
711.3.2 Membrane penetrations
By other listed materials and methods. 2....
-
404.2.10 Door and Gate Surfaces
Sliding doors shall not be required to comply with 404.2.10. 2....
-
206.2.4 Spaces and Elements
Reserved. 2. Reserved. 3. Reserved. Advisory 206.2.4 Spaces and Elements....
-
505.6 Gripping Surface
not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along their entire length where they are integral to crash rails or bumper guards. 2....
-
C.1. - Who within the agency is responsible for ensuring EIT purchases comply with Section 508?
acquiring the EIT) are responsible for: Identifying applicable technical provisions of the Access Board’s standards in their requirements documents (see FAR 11.002 and section B.2....
-
B1
1- 25 1 van-accessible space w/min. 96-inch-wide access aisle (van space) 26 - 50 1 space w/min. 60-inch-wide access aisle + 1 van space 51 - 75 2...
-
Responsibilities of Employees other than the CRO
[Sec. 382.61(a)(2)] You should be familiar with your carrier’s established procedures and the CRO’s duties and responsibilities with respect to resolving a complaint raised by a passenger...
-
Wheelchairs
[Sec. 382.41(e)(2)] • If the aircraft cabin does not contain a storage area of a size sufficient to accommodate a folding, collapsible, or breakdown wheelchair, you must stow the wheelchair...
-
205.1 General
Operable parts that are intended for use only by service or maintenance personnel shall not be required to comply with 309. 2....
-
11B-405.5 Clear width
a part of common use circulation paths shall be permitted to be decreased by work area equipment provided that the decrease is essential to the function of the work being performed. 2....
-
11B-505.6 Gripping surface
not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along their entire length where they are integral to crash rails or bumper guards. 2....
-
9. Broadening of Documentation Requirement for Undue Burden Exception
Section 1194.2 (a)(2) of the existing 508 Standards requires agencies to provide supporting documentation when determining that procurement of a compliant product would impose an undue burden...
-
Managed Use
Managed Use indicates management intent to accommodate a specific use. 2. There can be more than one Managed Use per trail or trail segment. 3....