[See subsections ...]
Search Results "RERC Rec-Tech: Rehabilitation Engineering Research Center on Recreational Technologies"
-
408 Display Screens
-
407.8 Reach Height and Depth
At least one of each type of operable part of stationary ICT shall be at a height conforming to 407.8.2 or 407.8.3 according to its position established by the vertical reference...
-
602.1 General
Documentation that supports the use of ICT shall conform to 602.
-
Defining Requirements for EIT
[See subsections ...]
-
B.2.i. - What must an agency do to ensure its' acquisitions of EIT provide "comparable access"?
Unless an exception applies, an agency’s obligation to provide comparable access under Section 508 is satisfied by acquiring EIT that meets the applicable technical provisions in...
-
B.6.iii. - Is undue burden the only grounds for acquiring EIT that does not meet the applicable technical provisions?
No. There are several exceptions to the requirements of Section 508 (see section G).
-
G.6.iii. - Can "significant expense" be established simply by demonstrating that a product that meets the applicable technical provisions is significantly more expensive than one that does not?
No. In determining whether acquisition of EIT that meets all or part of the applicable technical provisions of the Access Board's standards would impose an undue burden, an agency...
-
G.5.i. - What is the "back office" exception?
The so-called "back office" exception, discussed at Section 1194.3 of the Access Board's standards, states that "Products located in spaces frequented only by service personnel for...
-
D.2. - Must requiring officials consider all the Access Board’s technical provisions and functional performance criteria each time they purchase EIT?
No. Requiring officials need only consider all applicable technical provisions from the Access Board’s standards to ensure acquired products provide comparable access (see section...
-
E202.3 Federal Contracts (Section-by-Section Analysis)
E202.3 Federal Contracts (Section-by-Section Analysis) This section proposes that ICT acquired by a contractor that is incidental to a contract would not be required to conform to...
-
E202.3 Federal Contracts
ICT acquired by a contractor incidental to a contract shall not be required to conform to the 508 Standards. Advisory E202.3 Federal Contracts. ICT that is incidental to a...
-
408 Display Screens
[See subsections ...]
-
407.12 Reach Height
At least one of each type of operable part of stationary ICT shall be at a height conforming to 407.12.2 or 407.12.3 according to its position established in 407.12.1 for a side...
-
602.1 General
Documentation that supports the use of ICT shall conform to 602. Advisory 602.1 General. Examples of documentation that supports ICT are installation guides, user guides, and...
-
11B-411.1 General
Destination-oriented elevators shall comply with Section 11B-411 and with ASME A17.1. They shall be passenger elevators as classified by ASME A17.1. Elevator operation shall be...
-
11B-810.9 Escalators
Where provided, escalators shall comply with the sections 6.1.3.5.6 and 6.1.3.6.5 of ASME A17.1 and shall have a clear width of 32 inches (813 mm) minimum. Exception: Existing...
-
407.1 General
Elevators shall comply with 407 and with ASME A17.1 (incorporated by reference, see "Referenced Standards" in Chapter 1). They shall be passenger elevators as classified by ASME...
-
The Most Common DESIGN Errors
◼ The Most Common DESIGN Errors (11/17/00) Click here to view or download "The Most Common DESIGN Errors" (75.7 KB pdf)
-
4.10.6* Door Protective and Reopening Device
Elevator doors shall open and close automatically. They shall be provided with a reopening device that will stop and reopen a car door and hoistway door automatically if the door...
-
A4.10.6 Door Protective and Reopening Device
The required door reopening device would hold the door open for 20 seconds if the doorway remains obstructed. After 20 seconds, the door may begin to close. However, if designed in...
-
4.10.1 General
Accessible elevators shall be on an accessible route and shall comply with 4.10 and with the ASME A17.1‒1990, Safety Code for Elevators and Escalators. Freight elevators shall not be...
-
A4.10.6 DOOR PROTECTIVE AND REOPENING DEVICE
The required door reopening device would hold the door open for 20 seconds if the doorway remains unobstructed. After 20 seconds, the door may begin to close. However, if designed in...
-
11B-411.1 General
Destination-oriented elevators shall comply with Section 11B-411 and with ASME A17.1. They shall be passenger elevators as classified by ASME A17.1. Elevator operation shall be...
-
11B-810.9 Escalators
Where provided, escalators shall comply with the sections 6.1.3.5.6 and 6.1.3.6.5 of ASME A17.1 and shall have a clear width of 32 inches (813 mm) minimum. Exception: Existing...