Edge protection is not required at: ramps no higher than 6” that have side flares ramp landings serving an adjoining run or stairway sides of ramp landings with...
Search Results "Flared Side"
Commonly Searched Documents
-
Edge Protection [§405.9]
-
American Specialties Concealed Mounting Grab Bar 3100-Series
Requires the Premium User plan or above. (Login or upgrade your account!)
-
Bobrick Straight Grab Bar B-5806 Details
Requires the Premium User plan or above. (Login or upgrade your account!)
-
American Specialties Snap Flange Concealed Mounting Grab Bar 3700-Series 3D Model
Requires the Premium User plan or above. (Login or upgrade your account!)
- Kohler C3® 125 Elongated Bidet Toilet Seat With Side Controls and Tank Heater
-
R305.1.3 Contrast
Visual contrast may be provided on the full surface of the curb ramp but should not extend to flared sides....
-
9. When ramp access is provided to one side of a crawl tube and the other side is only entered by transfer access, how is it counted (ramp or transfer access play component)?
When ramp access is provided to one side of a crawl tube and the other side is only entered by transfer access, how is it counted (ramp or transfer access play component)?...
-
M305.1 General
Supports shall comply with M305.
-
M305.1 General (Section-by-Section Analysis)
This is an introductory section.
-
M305.1 General
Supports shall comply with M305, as applicable.
-
R304.5.1 Width
If provided, flared sides of curb ramp runs and blended transitions shall be located outside the width of the curb ramp run or blended transition....
-
1127B.5, Item 4
level landing 4 feet (1219 mm) deep shall be provided at the upper end of each curb ramp over its full width to permit safe egress from the ramp surface, or the slope of the fanned or flared...
-
5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations
5.8.1.2.2 Single Ramped Entry - Edge Protection on the Platform and Platform Sides Recommendations The Committee recommends a two-inch high edge protection on the back of the platform...
-
407.8.2.1 Unobstructed Side Reach
Where the operable part is located 10 inches (255 mm) or less beyond the vertical reference plane, the operable part shall be 48 inches (1220 mm) high maximum and 15 inches (380 mm)...
-
407.12.2.1 Unobstructed Side Reach
Where the operable part is located 10 inches (255 mm) or less beyond the vertical reference plane, the operable part shall be 48 inches (1220 mm) high maximum and 15 inches (380 mm)...
-
R207.1 General
The curb ramp (excluding any flared sides) or blended transition shall be contained wholly within the width of the pedestrian street crossing served....
-
11B-705.1.2.2.1 Perpendicular curb ramps
Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
-
Appendix 2: Survey Forms: Curb Ramps
sides)?...
-
Clear Floor Space: Minimum Clear Floor Space Required for Forward and Side Approach - Scooter
This data depicts the amount of clear floor area required by persons using wheeled mobility devices when performing a forward or side reach to a target location (e.g., reaching to a...
-
11 [§ 4.7.6]
Built-up curb ramps should have flared sides with a slope of 10 percent or less or have edge protection and handrails on the sides....
- Kohler C3® 125 Elongated Bidet Toilet Seat With Side Controls and Tank Heater Video
-
1 [§ 4.7.3]
If the curb ramp has flared sides, which can also be seen in the illustration to the right [below], do not include them in the measurement....
- Proline Drain: Quick Drain USA - Side Waste Outlet Tub to Shower Conversion
-
406.8--Modification to 406 of Appendix D to 36 CFR Part 1191
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...