Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
Search Results "Fire-Building Surface"
Filters
Commonly Searched Documents
-
703.6.2 Finish and Contrast
-
403.5.3 Passing Spaces
Passing spaces shall be either: a space 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum; or, an intersection of two walking surfaces providing a T-shaped space complying with...
-
703.6.2 Finish and Contrast
Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
-
703.6.2 Finish and Contrast
Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
-
1009.5.4 Transfer Steps
The surface of the bottom tread shall extend to a water depth of 18 inches (455 mm) minimum below the stationary water level. Advisory 1009.5.4 Transfer Steps....
-
403.5.1 Clear Width
Except as provided in 403.5.2 and 403.5.3, the clear width of walking surfaces shall be 36 inches (915 mm) minimum....
-
1132A.4, Item 3
Secondary exterior doors onto decks, patios, or balcony surfaces constructed of impervious materials (e.g., concrete, brick, flagstone) may have a maximum change in height from the interior...
-
407.2 Contrast (Section-by-Section Analysis)
407.2 Contrast (Section-by-Section Analysis) This section proposes that keys and controls, where provided, contrast visually from background surfaces....
-
5.3.6 Entrance
The entrance to the toilet shall be level with the surrounding surface....
-
4.9.4(2)
At the top, the extension shall be parallel with the floor or ground surface....
-
5.3.6 Entrance
The entrance to the toilet shall be level with the surrounding surface....
-
1016.6 Openings
Openings in the surface of outdoor recreation access routes shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1016.6 Openings....
-
Error/Omission: Landing areas where ramps change direction (e.g., switchbacks or 90° turns) are too small.
Result: Wheelchair users are unable to go up or down the ramp because there is not enough space to turn on a level surface. This makes the ramp unusable....
-
11B-703.7.2.7 Pedestrian traffic-control buttons
Control buttons shall be located no higher than 48 inches (1219 mm) above the ground surface adjacent to the pole....
-
Kurt Knight: Development of VA Standards
We don’t use it in other types of functions that don’t change as rapidly as a clinic building or a bed building....
-
ADA Standards for Accessible Design Pocket Guide: ADA Standard Section 2010
The complete guide to the 2010 ADA Standards for Accessible Design with notes provided by national accessibility experts Evan Terry Associates
-
11B-208.2.1 Hospital outpatient facilities
Ten percent of patient and visitor parking spaces provided to serve hospital outpatient facilities, and free-standing buildings providing outpatient clinical services of a hospital, shall...
-
11B-404.2.7 Door and gate hardware
In addition to the requirements of this section, designers should be aware of the Part 12, Section 12-10-202(f) requirement for lever hardware as adopted by the State Fire Marshal. ...
-
1011.3 Operable Parts
Exception 1 requires fire rings, grills, fireplaces, wood stoves, water hydrants, and water utility hook-ups to comply with the technical requirements for operation in 309.4 of the Architectural...
-
1.6.18 Terminal.
Each non-sterile area that is housed in a separate building is considered a separate terminal, and any sterile area that can be accessed only through a specific checkpoint or checkpoints...
-
TABLE OF CONTENTS
Accessibility Evaluating the Physical Accessibility of Polling Places Getting Started Parking Passenger Drop-off Locations Accessible Routes Ramps Protruding Objects Building...
-
802.1.5 Overlap
The term "circulation paths" used in 802.1.5 means aisle width required by applicable building or life safety codes for the specific assembly occupancy....
-
Accessible Route
A continuous unobstructed path connecting all accessible elements and spaces of a building or facility....