End transfer surfaces shall be 28 inches (710 mm) wide minimum and 17 inches (430 mm) long minimum. ...
Search Results "Transfer Technique"
-
M301.2.3.1 End Transfer Surface
-
M301.2.3.2 Side Transfer Surface
Side transfer surfaces shall be 28 inches (710 mm) wide minimum and 28 inches (710 mm) long minimum....
-
A4.16.4 Grab Bars
A6(a) and (b) show the diagonal and side approaches most commonly used to transfer from a wheelchair to a water closet....
-
A4.16.4 GRAB BARS
A5(a) and (b) show the diagonal and side approaches most commonly used to transfer from a wheelchair to a water closet....
-
2004 ADA and ABA Accessibility Guidelines
The following technical criteria in the proposed standards are based on the 2004 ADA and ABA Accessibility Guidelines: • Height of transfer surfaces on diagnostic equipment used by patients...
- Figure 608.2.1 Transfer Type Shower Compartment Size and Clearance – Drawing from the U.S. Access Board
-
M301.3.1 Transfer Supports (Section-by-Section Analysis)
The MDE NPRM proposed to require transfer supports to be provided for use with transfer sides on diagnostic equipment used by patients in the supine, prone, or side-lying position, and that...
- Autoadapt Turny Evo
-
206.2.9.2 Wheelchair Spaces, Ride Seats Designed for Transfer, and Transfer Devices
206.2.9.2 Wheelchair Spaces, Ride Seats Designed for Transfer, and Transfer Devices....
-
5.3 Transfer Sides
5.3 Transfer Sides....
-
F206.2.8.2 Wheelchair Spaces, Ride Seats Designed for Transfer, and Transfer Devices
When amusement rides are in the load and unload position, wheelchair spaces complying with 1002.4, amusement ride seats designed for transfer complying with 1002.5, and transfer devices...
-
206.2.9.2 Wheelchair Spaces, Ride Seats Designed for Transfer, and Transfer Devices
When amusement rides are in the load and unload position, wheelchair spaces complying with 1002.4, amusement ride seats designed for transfer complying with 1002.5, and transfer devices...
-
4.21.4 Grab Bars
On the one hand, transfers are typically only made into shower chairs outside the shower and with a caregiver’s assistance....
-
Parking Spaces
Parking Spaces Measure from the center of marking lines. If lines are not adjacent to another space or aisle the measurement can be to the full width of the line.
-
1.1.8 Alternate measurement tools
1.1.8 Alternate measurement tools. Walks may be measured with instruments other than a digital inclinometer if they provide the data required for evaluation of tolerances as given in...
-
1.1.13 Flatness of ramp running slope
1.1.13 Flatness of ramp running slope. Measure flatness in the running slope of ramps at 12 - in. (300 mm) increments by using successive, overlapping 24 - in. (600 mm) lengths using...
-
1.1.3 Walk running slope
1.1.3 Walk running slope. Measure for overall running slope (the primary direction of travel) by determining elevations at the ends of the walk, noticeable changes in slope, or at a...
-
Entry Points and Seats
Entry Points and Seats Entry points and seats are features of play components where individuals would transfer, sit, or gain access....
-
5.1.3 Transfer Surface Low Height Options for M301 and M302
5.1.3 Transfer Surface Low Height Options for M301 and M302 The Committee did not agree on a final low height recommendation....
-
Minimum Number: ADA Standard Section 234.3
Section 234.3 covers scoping requirements in the current ADA Standards for the minimum number of wheelchair spaces required at amusement rides.
-
12162(a)(2)(D)(iii)
(iii) have a seat to which a passenger in a wheelchair can transfer, or a space to fold and store such passenger's wheelchair; or...
-
12162(a)(2)(B)(iii)
(iii) have a seat to which a passenger in a wheelchair can transfer, and a space to fold and store such passenger's wheelchair; and...
-
1014.2 Entrance
This section requires camp shelters to provide either transfer access or roll-in access at the entrance to the camp shelter....
-
11B-234.3 Minimum number
Amusement rides shall provide at least one wheelchair space complying with Section 11B-1002.4, or at least one amusement ride seat designed for transfer complying with Section 11B-1002.5...