The MDE NPRM proposed a transfer surface size for diagnostic equipment used in the supine, prone, or side-lying position of 30 inches wide and 15 inches deep minimum....
Search Results "Side Reach"
Filters
Commonly Searched Documents
-
M301.2.3 Size (Section-by-Section Analysis)
-
Doors
DOORS 32” clear width 11B-404.2.3 Maneuvering clearances 11B-404.2.4.1 Level landings each side...
-
Doors
DOORS 32” clear width 11B-404.2.3 Maneuvering clearances 11B-404.2.4.1 Level landings each side...
-
A4.17.3 Size and Arrangement
A standard stall provides a clear space on one side of the water closet to enable persons who use wheelchairs to perform a side or diagonal transfer from the wheelchair to the water closet...
-
M301.1 General
Where diagnostic equipment is used by patients in a supine, prone, or side-lying position, it shall comply with M301....
-
M301.2.3 Size
The size of transfer surfaces shall be measured from center points of their opposing sides....
-
5.2.1.1 Transfer Surface Width
The transfer surface should be 28 inches wide minimum for equipment used by patients in a supine, side-lying, or prone position....
-
5.2.1.2 Transfer Surface Depth
The transfer surface should be 17 inches deep minimum for all equipment used by patients in a supine, side-lying, or prone position with the exception of imaging equipment....
-
M301.1 General
Diagnostic equipment that supports patients in a supine, prone, or side-lying position shall comply with M301. ...
-
M301.2.1 Transfer Surface Height
The table side covers have the same issues discussed for the CT table in Figure 5.3-1....
-
Midmark 647 Barrier-Free® Power Podiatry Procedures Chair
plush design for highend appearance and unparalleled comfort Programmability: Three positions that you customize to your needs Electrical Outlets: Duplex, hospital grade (on each side...
-
Landscape Forms Inc. Sort Recycling Units
Distinctive top shape makes openings highly visible and easy to reach, sheds water, and protects contents....
-
Utilities at Recreation Sites
in "Reach Ranges and Operability Requirements” of this guidebook....
-
M301.3.1 Transfer Supports (Section-by-Section Analysis)
The MDE NPRM proposed to require transfer supports to be provided for use with transfer sides on diagnostic equipment used by patients in the supine, prone, or side-lying position, and that...
-
M305.2.1 Location (Section-by-Section Analysis)
The MDE NPRM proposed that transfer supports be located within reach of the transfer surface and not obstruct transfer onto or off of the surface when in position (proposed M305.2.1)....
-
M305.2.3 Fittings
M305.2.3 Fittings Proposed requirement: Transfer supports shall not rotate within their fittings • Sub-Committee Recommendation: Transfer supports shall not rotate within...
-
Overhead Lifts
The technical criteria do not address overhead lifts that are usually mounted on the ceiling and operate on tracks suspended over the diagnostic equipment because the configuration...
-
Clearance in Base (M301.4.1 and M302.4.1)
Clearance in the base of the equipment allows the legs of a portable floor lift to fit under the base of the equipment. The clearance can be an open area between the supporting posts...
-
M301.3.2 Leg Supports (Section-by-Section Analysis)
In the MDE NPRM, the Access Board proposed to place the requirements for stirrups on diagnostic equipment used by patients in the supine, prone, or side-lying position in M301....
-
M301.3.1 Transfer Supports
Transfer supports shall be provided for use with the transfer sides required by M301.2.3 and shall comply with M305.2....
-
Magnuson Group RETTO Outdoor Waste Receptacle
Designed by Mattiussi Ecologia Spa, RETTO is a sturdy, front-loading receptacle with 26-gallon capacity that combines strong functional elements and rectilinear...
-
Pilot Rock BPR1 Bear Resistant Trash Receptacle
Series Overview Model BPR1 Bear Resistant Trash and Recycling Receptacle With 1 Module is designed … and tested … to keep bears out. It has been CERTIFIED by the Living With...
-
Pilot Rock CN-S7101A Kolorcans Round Trash Receptacle With Dome Lid
Model CN-S7101A is a round trash receptacle with dome lid and has a 42 gallon capacity. Made from rotationally molded polyethylene plastic which is a durable, heavy weight...
