Character height measured vertically from the baseline of the character shall be 5/8 inch (16 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter "I"....
Search Results "Vertical Access"
Filters
Commonly Searched Documents
-
703.2.5 Character Height
-
R405.1 General
Clearances are measured in relation to the usable clear space, not necessarily to the vertical support for an element....
-
504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
1008.3.2.3 Transfer Supports
Some examples of supports include a rope loop, a loop type handle, a slot in the edge of a flat horizontal or vertical member, poles or bars, or D rings on the corner posts....
-
7.4.5.1 Size
Vertical alignment at the intersection of the trails that form the T-shaped space shall be nominally level....
-
Spout Location [4.15.3]
The trajectory of water flow must be vertically "parallel" or "nearly parallel" to the face of the unit....
-
§ 38.73(d)(1) Requirements
Vertical alignment may be accomplished by vehicle air suspension, automatic ramps or lifts, or any combination....
-
11B-703.2.5 Character height
Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”....
-
Preserving elevator access in building where it might not be required.
However, the building has an elevator, which currently provides access to all 6 floors and a mezzanine between the first and second floors. ...
-
Can a single EV charger service two EV Accessible spots or does each spot have to have its own charger?
RESPONSE: A single multiport EV charger that can simultaneously charge two vehicles can be used to serve two EV spaces required to be accessible....
-
Wireless RERC: Accessibility, Usability, and the Design of Wearables and Wirelessly Connected Devices
As augmentative tools for work and living enhancement, and social participation, these technologies should be not only usable, but also be accessible and inclusive for people with disabilities...
-
D.2. - Must requiring officials consider all the Access Board’s technical provisions and functional performance criteria each time they purchase EIT?
Requiring officials need only consider all applicable technical provisions from the Access Board’s standards to ensure acquired products provide comparable access (see section B.2.ii, above...
-
18. Where an existing ground level play component is replaced, should the new component comply with the technical provisions of Section 1008.4 even if there is not an accessible route to it?
Unless the required number of accessible ground level play components are provided, the new play component would be required to be accessible....
-
11B-703.2.5 Character height
Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”. ...
-
504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
4.5.2 Changes in Level
Changes in level up to 1/4 in (6 mm) may be vertical and without edge treatment (see Fig. 7(c))....
-
4.5.2 CHANGES IN LEVEL
Changes in level up to 1/4 in (6 mm) may be vertical and without edge treatment (see Fig. 7(c))....
-
Handrails [§504.6, §505]
A vertical clearance 9” minimum between upper and lower handrails will help prevent entrapment....
-
§ 38.23(b)(8) Platform entrance ramp
loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, measured on level ground, for a maximum rise of 3 inches, and the transition from roadway or sidewalk to ramp may be vertical...
-
International Code Council (ICC): Become an ICC Certified Accessibility Inspector/Plans Examiner
Demands for Accessible Buildings Are Growing: Become an ICC Certified Accessibility Inspector/Plans Examiner now The 2010 U.S....
-
Re: Single User Restroom Accessibility
Section 11B-202.3.2 indicates that "an alteration of an existing element, space, or area of a building or facility shall not impose a requirement for accessibility greater than new construction...
-
Corbin Russwin Inc. ED7000 Series Narrow Stile Crossbar Exit Device
The ED7000 Series are available as Rim, Surface Vertical Rod, Mortise and Concealed Vertical Rod devices. ...
-
PDQ 4200 Series Exit Device Door Hardware
The American Eagle 4200 Series is a rim or surface vertical rod exit device....
-
Figure 610.3 Extent of Seat – Drawing from the U.S. Access Board
