If "self parking" is provided, are at least the minimum number of accessible parking spaces provided as required by the table below in surface lots or parking garages, including "van accessible...
Search Results "Curb Ramp Surface"
-
A. Self Parking
-
2. Shared Use Paths
address access to sidewalks, streets, and other pedestrian facilities, provide requirements for pedestrian access routes, including specifications for route width, grade, cross slope, surfaces...
-
11B-609.3 Spacing
Configuration) the space between the walls and the grab bar shall be 1½ inches (38 mm) minimum for a distance of 6 inches on either side of the inside corner between two adjacent wall surfaces...
-
Clear Floor Space [4.16.2]
cannot swing into the clear floor space required at any fixture the 18 inch water closet centerline is absolute The 18 inch dimension is measured from the finished wall surface...
-
Signage [4.6.4]
Access symbols on the parking surface, sometimes required locally, are obscured by vehicles parked in the space and cannot substitute for post- or wall-mounted signage....
-
Maintenance
Maintaining trail tread and access routes, such as filling ruts, reshaping a trail bed, replacing or reshaping surfacing material, repairing washouts, installing riprap to retain cut and...
-
Mounting Location and Height [4.30.6]
Where adequate wall space is not available on the latch-side, signs are to be placed on the nearest adjacent wall surface....
-
6.1 General
Beach access routes shall be permanent or removable surfaces....
-
Conclusion
We perceive the world, in part, through pressure and movement of materials and surfaces against our skin, and we sense the instantaneous positions of our limbs as we move through, and take...
-
Identification [§216.5, §502.6]
ISA designations on the parking surface, even if required by a state or local government, cannot substitute for above-ground signs that remain visible at all times....
-
11B-609.3 Spacing
Configuration) the space between the walls and the grab bar shall be 1½ inches (38 mm) minimum for a distance of 6 inches on either side of the inside corner between two adjacent wall surfaces...
-
2. Shared Use Paths
address access to sidewalks, streets, and other pedestrian facilities, provide requirements for pedestrian access routes, including specifications for route width, grade, cross slope, surfaces...
-
2. Shared Use Paths
address access to sidewalks, streets, and other pedestrian facilities, provide requirements for pedestrian access routes, including specifications for route width, grade, cross slope, surfaces...
-
11B-609.3 Spacing
Section 11B-609.9 the space between the walls and the grab bar shall be 1½ inches (38 mm) minimum for a distance of 6 inches on either side of the inside corner between two adjacent wall surfaces...
-
7.0 APPLICATION
Where existing individual site features are altered but the floor or ground surface under or around them is not altered, the clear floor or ground space shall not be required to comply with...
-
A. Arena Assembly Seating:
The floor surface of the companion seat shall be at the same elevation as the floor surface of the wheelchair space....
-
II. Rulemaking History
The committee members reached a consensus on all of their recommendations, except for the recommended lowest or minimum height for adjustable-height transfer surfaces....
-
References
Accessible Exterior Surfaces Technical Article. Washington, D.C.: U.S. Access Board. Axelson, P. W., Yamada, D. A., Kirschbaum, J. B., Longmuir, P....
-
Notes
ANSI/AAMI HE75 recommends that the height of patient support surfaces "should be easy to adjust (ideally, powered) to suit the needs of health care professionals and patients."...
-
Providing Comforts and Conveniences—Constructed Features
However, if the ground under the element isn't changed, this work doesn't trigger the surface and slope requirements for clear floor and ground space....
-
Bradley Stainless Steel Double Robe Hook 9124, 9125
Bradley Stainless Steel Double Robe Hook Model 9124, 9125 Surface-Mounted - Concealed Mounting Stainless Steel Vandal-Resistant Escutcheons Model 9124: Satin...
-
Bradley Standard Series Napkin Disposal
Models 4721-15, 4722-15, 4731-15 available BradEX 4721-15 partition mounted, serves 2 compartments 4722-1015 semi-rcessed, serves an end compartment 4722-15 surface...
-
Just Manufacturing Undermount Group Oval Lavatory with Overflow
Exposed surfaces polished with a satin blended No. 4 finish. Smooth, fully coated underside. Conforms to ASME/ANSI A112.19.3M....
-
Wikk Industries Inc. PART#BPS SM-INGR CLEAR (628) with I36-3 CLEAR (628)
6”X6”X42” Tall, Clear Anodized Aluminum (628), Surface mount with concealed mounting base, 1 prep for INGRESS’R® ADA switch, Removable Black ABS cap Shown on the bollard- I36-3 Clear...
