When glass is used, it shall have minimum thickness of not less than 1/8 inch (3.17 mm) when fully tempered, or 1/4 inch (6.35 mm) when laminated, and shall pass the test requirements of...
Search Results "Regarded as Having an Impairment"
Filters
Commonly Searched Documents
-
1134A.5, Item 5
-
1134A.6, Item 7
When glass is used, it shall have minimum thickness of not less than 1/8 inch (3.17 mm) when fully tempered, or ¼ inch (6.35 mm) when laminated, and shall pass the test requirements of this...
-
402.2.2 Braille Instructions (Section-by-Section Analysis)
402.2.2 Braille Instructions (Section-by-Section Analysis) This section proposes that, where displays for ICT with closed functionality are required to have speech output, instructions...
-
10.2.1(1)
(1) Where new bus stop pads are constructed at bus stops, bays or other areas where a lift or ramp is to be deployed, they shall have a firm, stable surface; a minimum clear length of 96...
-
904.6 Security Glazing
Where counters or teller windows have security glazing to separate personnel from the public, a method to facilitate voice communication shall be provided....
-
A4.16.5 Flush Controls
Flush controls for tank-type toilets have a standardized mounting location on the left side of the tank (facing the tank)....
-
“No Service” Backup Plans
It is important to store important contacts in a separate location and have a plan for accessing your contacts when your mobile device does not work....
-
4. I understand that a waiver from accessibility requirements may be obtained?
Such findings have specific meaning and must be approved and recorded by the building department at the time an alteration is made. There is no such thing as a retroactive waiver....
-
A4.23.3 Clear Floor Space
Since the shower does not have a lip, the floor space can be used for required maneuvering space....
-
Door Hardware [4.13.9]
Door Hardware [4.13.9] Hardware used to operate doors, including handles, pulls, latches and locks, must have a shape that is "easy to grasp with one hand" and does not require tight...
-
A4.16.5 FLUSH CONTROLS
Flush controls for tank-type toilets have a standardized mounting location on the left side of the tank (facing the tank)....
-
III-9.6000 Procedure following preliminary denial of certification
The submitting official will have at least 15 days to submit relevant material in opposition to the preliminary denial....
-
1017.7.1 Maximum Running Slope and Segment Length
This section requires that not more than 30 percent of the total length of a trail have a running slope steeper than 1:12 (8.33%), and that the running slope of any segment of a trail not...
-
§100.205(a)
(a) Covered multifamily dwellings for first occupancy after March 13, 1991 shall be designed and constructed to have at least one building entrance on an accessible route unless it is impractical...
-
Individuals with Partial or Total Vision Loss
Individuals with Partial or Total Vision Loss Individuals with vision loss usually will have independent mobility for use of roads and shared use paths as pedestrians....
-
4.1.6(4)(a)
Curb ramps and ramps to be constructed on existing sites or in existing buildings or facilities may have slopes and rises as shown in Table 2 if space limitations prohibit the use of a 1...
-
Must elevator doors remain open for 20 seconds?
Reopening devices must remain effective for 20 seconds minimum, but in reopening, doors do not have to remain open for this length of time if unobstructed....
-
Are detectable warnings required on curb ramps or at hazardous vehicular areas?
Curb ramps at all other facilities are not required to have detectable warnings....
-
§ 35.101(b) Broad coverage
The primary object of attention in cases brought under the ADA should be whether entities covered under the ADA have complied with their obligations and whether discrimination has occurred...
-
1193.23(b)(4) (Advisory Guidance)
they can make reasonable efforts to validate any unproven access solutions through testing with individuals with disabilities or with appropriate disability-related organizations that have...
-
§ 35.138(c) Ticket prices
If tickets for accessible seating at a particular price level are not available because of inaccessible features, then the percentage of tickets for accessible seating that should have been...
-
1134A.5, Item 5
When glass is used, it shall have minimum thickness of not less than 1/8 inch (3.17 mm) when fully tempered, or 1/4 inch (6.35 mm) when laminated, and shall pass the test requirements of...
-
1134A.6, Item 7
When glass is used, it shall have minimum thickness of not less than 1/8 inch (3.17 mm) when fully tempered, or ¼ inch (6.35 mm) when laminated, and shall pass the test requirements of this...
-
1132A.5.1 General
The floor or landing on the dwelling unit side of the primary entry door and any required exit door shall have a minimum length of not less than 44 inches (1118 mm)....