In the final rule, the Board has revised the dispersion requirement to allow some overlap (10% maximum) between rooms and to ensure that at least one room provides both wheelchair access...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
Filters
Commonly Searched Documents
-
Dispersion
-
5.8.1.2.1 Ramped Entry Slope Recommendations
The maximum slope for a ramp in the 2010 Standards is a rise of 1 vertical inch for each 12 inches of horizontal distance slope....
-
Introduction
104.1.1 and clarified in its advisory, they are intended to apply only to certain sections of the 2010 ADA Standards where dimensions are stated as single dimensions or as simple minimums or maximums...
-
Conclusions
The maximum values recorded for thigh breadth and shoulder breadth serves as a reference value should accommodations for these users be necessary....
-
M301.2.3 Transfer Sides
Guidance from IEC 60601-2-52 does establish the maximum vertical obstruction of being not less than 1" below the top of the transfer surface....
-
Key Study findings:
Of the participants who attempted and were successful with performing two-step transfers, the 50th percentile could attain a 7 inch vertical height difference which is below the maximum...
-
Protocol A Heights Obtained
The upper 95th percentile transfer heights were 3" higher for the NDVWSC than the HERL group for the maximum height transfer....
-
1. Sloped Surfaces
The maximum running slope generally allowed for ramps is 1:12 (8.33% or 4.76 degrees). Cross slope is the slope or grade of a surface perpendicular to the running slope....
-
Circulation Paths
Free-standing objects mounted on posts or pylons may overhang 12 in (305 mm) maximum from 27 in to 80 in (685 mm to 2030 mm) above the ground or finished floor (see Fig. 8(c) and (d))....
-
11B-406.5.3 Landings
The slope of the landing in all directions shall be 1:48 maximum. [2010 ADA Standards] 406.4 Landings. Landings shall be provided at the tops of curb ramps....
-
White House Testimony
A final administration position is often determined as much the force of personality, influence, and respect of key officials as according to specific position in a decision-making structure...
-
Section 37.73 Purchase or Lease of Used Non-Rail Vehicles by Public Entities Operating a Fixed Route System
This is because, at the time of its remanufacture, the bus would have been made as accessible if feasible....
-
BEST Door Lever Hardware Cylindrical Locks - 9K
The innovative design of the slotted key release cam and locking lug assembly create maximum attack resistance. Even though damaged, the lock still allows key access....
-
Allegion Falcon 1490 Series Exit Devices
Sizes: 36", 42", 48" Doors: 1 3/4" thick metal doors-specify if other than 1 3/4" Projections: 2 3/4" maximum, 2" when dogged....
-
Midmark 630 HUMANFORM™ Procedures Table
seat height and 650-pound weight capacity Power height, back, foot and tilt Hand and foot controls standard Patient Weight Capacity: 650 lb (295 kg) Height: Minimum 18" (45.7 cm), Maximum...
-
AJW Architectural Products U1521EA Series Automatic 120 Volt Hand Dryer, Satin Finish - Surface Mounted
Base: One piece #14 ga steel with 3/4" returns to wall surface for maximum strength and rigidity....
-
Symmons Ultra-Sense Battery Powered Sensor Faucet S-6060
Sensor Activated Lavatory Faucet with infrared Position Sensitive Detection (PSD) system Electronic components are sealed above deck in cast brass body for easy installation, service and maximum...
-
Allegion Falcon MA Series Mechanical Locks
Spindles are independent, designed to ‘break-away’ at a maximum of 480 in./lbs. to prevent damage to the lock chassis. Non-handed curved lip strikes are standard....
-
RESNA Standards Committee on Inclusive Fitness
beneficialdesigns.com Vice Chair: Peter Axelson peter@beneficialdesigns.com Secretary: Jaime McGuire jaime@beneficialdesigns.com This new committee will develop guidelines and/or technical...
-
The National Association of Councils on Developmental Disabilities (NACDD)
The Role of NACDD To provide technical assistance to all DD Councils To advocate for the national public policy agenda To advocate for DD Councils’ appropriations in Congress...
-
Michigan Rehabilitation Services (MRS)
In addition, MRS partners and collaborates with the State Department of Education, local school systems, Michigan Career and Technical Institute (MCTI), community colleges, four-year colleges...
-
National Center for College Students with Disabilities (NCCSD)
The NCCSD has three purposes: Provide technical assistance and information to anyone needing information about disability and higher education, including college students, their families...
-
Independent Living Resource Center (ILRC) - Albuquerque, Alamogordo, Moriarty, and Socorro, NM
The Technical Services Program is also available in Chavez, Doña Ana, Eddy, Lea, Luna, and Roosevelt Counties....
-
6. May an employer ask an individual for documentation when the individual requests reasonable accommodation?
employer may ask the employee for documentation describing the impairment; the nature, severity, and duration of the impairment; the activity or activities that the impairment limits; and the extent...
