Grab bars shall be installed in any manner that provides a gripping surface at the specified locations and that does not obstruct the required clear floor space....
Search Results "Wet Bar"
Filters
Commonly Searched Documents
-
11B-609.7 Installation
-
11B-608.3.1 Transfer type shower compartments
In transfer type compartments, grab bars shall be provided across the control wall and back wall to a point 18 inches (457 mm) from the control wall....
-
1134A.5, Item 2
Reinforced walls for grab bars. A bathtub installed without surrounding walls shall provide reinforced areas for the installation of floor-mounted grab bars....
-
1134A.5, Item 2
Reinforced walls for grab bars. A bathtub installed without surrounding walls shall provide reinforced areas for the installation of floor-mounted grab bars....
-
Surface [1017.2]
through a ½-inch screen (rather than larger rocks) Rock material that is compacted in 3- to 4-inch layers (rather than thicker layers) Material that is moist (but not too wet...
-
4.26.3 STRUCTURAL STRENGTH
The structural strength of grab bars, tub and shower seats, fasteners, and mounting devices shall meet the following specification: (1) Bending stress in a grab bar or seat induced by...
-
11B-809.10.8 Lavatories, vanities, mirrors and towel bars
Where mirrors or towel bars are provided, no less than one of each shall comply with this section....
-
1134A.7, Item 2
Reinforced walls for grab bars. ...
-
1134A.7, Item 2
Reinforced walls for grab bars....
-
Sec.36.304(b)(12)
(12) Installing grab bars in toilet stalls;...
-
§ 36.304(b)(12)
(12) Installing grab bars in toilet stalls;...
-
Effect of Handhelds on Transfer Height
Participant preference for grab bars and backrest heights for protocols B through E are shown in Table 17. For all protocols the tall grab bars were preferred....
-
4.26.3 Structural Strength
The structural strength of grab bars, tub and shower seats, fasteners, and mounting devices shall meet the following specification:...
-
11B-608.3.2 Standard roll-in type shower compartments
Grab bars shall be provided on the back wall and the side wall opposite the seat. Grab bars shall not be provided above the seat. ...
-
11B-608.3.1 Reserved
[See subsections ...]
-
226 and 902 Dining Surfaces and Work Surfaces
226 and 902 Dining Surfaces and Work Surfaces Section 226.1 of the 2010 Standards require that where dining surfaces are provided for the consumption of food or drink, at least...
-
1018.2 Connections
Beach access routes shall connect an entry point to the beach to the: 1. High tide level at tidal beaches; 2. Mean high water level at river beaches; or 3. Normal...
-
Connections [1018.2]
Beach access routes must connect an entry point to the beach to the high tide level at tidal beaches (figure 30); the mean high water level at river beaches; and the normal...
-
Using the Beach Access Route Exceptions [1018.1, Exceptions 1 and 2]
When a condition for exception does not permit full compliance with a specific provision in the technical requirements on a portion of a beach access route, that portion of the route...
-
Scoping Requirements
[See subsections ...]
-
Gates and Barriers on Beach Access Routes
If gates or barriers are constructed to control access to beach access routes, include openings wide enough to allow hiker passage. Refer to the FSORAG for the technical provisions...
-
Beach Access Point
Beach Access Point—A site at which pedestrian access (such as dune crossings, stairways, walkways, or ramps leading from boardwalks or outdoor recreation access routes) to the beach...
-
Exceptions to the Guidelines That Apply to Beach Access Routes
When a condition for an exception prohibits full compliance with a specific technical requirement on a portion of a beach access route, that portion of the beach access route must...
-
1018.1 General
This section contains the technical requirements for beach access routes. The technical requirements address connections (1018.2); surface (1018.3); clear width (1018.4); obstacles...