Seating, tables, or work surfaces 4.30 If provided in accessible spaces, at least one of each type provided....
Search Results "Stable Surface"
Filters
Commonly Searched Documents
-
12. Seating, tables, or work surfaces
-
1002.4.2 Slope
The floor or ground surface of wheelchair spaces shall have a slope not steeper than 1:48 when in the load and unload position....
-
M302.2 Transfer Surface
M302.2 Transfer Surface M302.2.3 Transfer Sides Proposed requirement: The transfer surface shall be located to provide options to transfer from a mobility device onto one short...
-
General: ADA Standard Section 226.1
Section 226.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for dining surfaces and work surfaces.
-
High work surface
All of the seating spaces/work surfaces were approximately 42" high....
-
Aluminum Swaged SG Series Pressure-Locked Grating
Slip resistant & serrated surfaces also available....
-
11B-226.1 General
Where dining surfaces are provided for the consumption of food or drink, at least 5 percent of the seating spaces and standing spaces at the dining surfaces shall comply with Section 11B...
-
302.3 Openings
Openings in floor or ground surfaces shall not allow passage of a sphere more than 1/2 inch (13 mm) diameter except as allowed in 407.4.3, 409.4.3, 410.4, 810.5.3 and 810.10....
-
Height: ADA Standard Section 902.4.2
The tops of tables and counters shall be 26 inches (660 mm) minimum and 30 inches (760 mm) maximum above the finish floor or ground.
-
Findings
The following are the predominant findings from this study: No single type of surface material/system was found to be the most accessible surface or better than others when comparing...
-
4.19.4 EXPOSED PIPES AND SURFACES
There shall be no sharp or abrasive surfaces under lavatories....
-
Why a smooth surface door or kickplate is important
And those nicks slice your fingers like butter when you least expect it.
-
4.19.4 Exposed Pipes and Surfaces
There shall be no sharp or abrasive surfaces under lavatories....
-
Dimensions for Adults and Children: ADA Standard Section 102
Section 102 of the ADA Standards covers information on the dimensions for adults and children.
-
11B-102 Dimensions for adults and children
this chapter includes technical requirements based on children’s dimensions and anthropometrics for drinking fountains, water closets, toilet compartments, lavatories and sinks, dining surfaces...
-
1.1.2 Walks
Measure walks and other non - ramp pedestrian surfaces for overall running slope and cross slope as well as local running slope and cross slope variations (flatness) in accordance with 1.1.3...
-
403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
Water Hydrants
The surface at the base of water hydrants at recreation areas must be firm and stable with a 60-inch turning radius. See the "Surfaces" rule of thumb above....
-
Tile Tech Pavers® Stamp-Tech™ Series Pavers
Its irregular top surface was developed from actual sections of stone. By rotating the direction of the pavers during installation the natural effect is complete....
-
Unity Surfacing Systems Soft-Land Rubberized Safety Surfacing
Soft-Land is "Unity's" 3", 3 1/4", 3 1/2" and 3 3/4" thick rubberized safety surfacing, flooring and paver products that are made from 100% recycled tires and rubber granules....
-
403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
Tread Obstacles [1017.5]
A tread obstacle is anything that interrupts the evenness of the tread surface....
-
1015.3 Height
Required guards shall not be less than 42 inches (1067 mm) high, measured vertically as follows: From the adjacent walking surfaces....
