Every primary entrance to a residential dwelling unit with adaptable features shall be provided with a door buzzer, bell, chime or equivalent....
Search Results "Sliding Door"
Commonly Searched Documents
- 
    
  
  11B-809.8.4 Door signal devices
  
 - 
    
  
  Recessed Doors and Gates [§404.2.4.3]
  
Recessed Doors and Gates [§404.2.4.3] Thick walls, casework, shelving, columns and other elements can cause doors or gates to be recessed....
 - 
    
  
  1010.1.4.1 Revolving doors
  
Revolving doors shall comply with the following: 7. Revolving doors shall not be part of an accessible route required by Section 1009 and Chapter 11A or 11B....
 - 
    
  
  404.2.1 Revolving Doors, Gates, and Turnstiles
  
Revolving doors, revolving gates, and turnstiles shall not be part of an accessible route....
 - 
    
  
  404.2.1 Revolving Doors, Gates, and Turnstiles
  
Revolving doors, revolving gates, and turnstiles shall not be part of an accessible route....
 - 
    
  
  Maneuvering Clearance or Standby Power for Automatic Doors
  
Maneuvering Clearance or Standby Power for Automatic Doors. Section 4.13.6 of the 1991 Standards does not require maneuvering clearance at automatic doors....
 - 
    
  
  Doors and hardware
  
• Minimum-weight doors with accessible hardware are easily opened by people who have arthritis or use a cane for extra balance....
 - 
    
  
  Power Operation: ADA Standard Section 409.3.1
  
Section 409.3.1 covers the current ADA Standards for the power operation of private residence elevator doors.
 - 
    
  
  4.10.8 Door Delay for Car Calls
  
The minimum time for elevator doors to remain fully open in response to a car call shall be 3 seconds....
 - 
    
  
  4.10.8 DOOR DELAY FOR CAR CALLS
  
The minimum time for elevator doors to remain fully open in response to a car call shall be 3 seconds....
 - 
    
  
  Doors and Gates Operated Only By Security Personnel [§404.1, Ex]
  
Doors and Gates Operated Only By Security Personnel [§404.1, Ex] Manual doors, doorways, and gates that are designed to be operated only by security personnel, such as guards in...
 - 
    
  
  Door Hardware
  
A few commenters requested that lever hardware be required on doors throughout dwelling units, not only at the entry door to the dwelling unit. Response....
 - 
    
  
  Double Action Door Pressure Gauge
  
Double Action Door Pressure Gauge This Door Pressure Gauge, available from Evan Terry Associates, has Push-Pull capability and measures forces from 0-35 pounds on one side and 0-16...
 - 
    
  
  Low Energy Doors and Gates [§404.3]
  
Low Energy Doors and Gates [§404.3] Low energy doors and gates usually require activation by the user through a push plate or control and are often used in moderate traffic locations...
 - 
    
  
  SECTION 1132A DOORS
  
SECTION 1132A DOORS...
 - 
    
  
  Clear With [sic] [§404.2.3]
  
Clear With [sic] [§404.2.3] The clear width is measured from the stop to the face of doors or gates open 90⁰ (or to the leading edge of sliding or folding doors....
 - 
    
  
  A. Slope at Door
  
If a fully automatic door is not provided, is the walkway in front of the lobby door level, without any portion steeper than 1:50 (critical dimension of ´" or less), so persons who use wheelchairs...
 - 
    
  
  Salad Bars and Buffet Counters
  
Since it can be difficult to maneuver a wheelchair while balancing plates of food, tray or plate slides can greatly facilitate access but their effect on reach should be taken into account...
 - 
    
  
  304.4 Door Swing
  
Doors shall be permitted to swing into turning spaces....
 - 
    
  
  304.4 Door Swing
  
Doors shall be permitted to swing into turning spaces....
 - 
    
  
  Error/Omission: Adequate maneuvering clearance is not provided at doors, including doors to accessible toilet stalls.
  
Error/Omission: Adequate maneuvering clearance is not provided at doors, including doors to accessible toilet stalls....
 - 
    
  
  11B-603.2.3 Door swing
  
[2010 ADA Standards] 603.2.3 Door Swing. Doors shall not swing into the clear floor space or clearance required for any fixture....