Security Pull Materials: - Stainless steel Certification: - Meets ANSI A156.6 for J401 Pull Plates Note: - For wood doors
Search Results "Compartment Depth"
-
Hager Companies Security Pull T4E
-
Hager Companies Security Pull P4E
Security Pull Materials: - Stainless steel Certification: - Meets ANSI A156.6 for J401 Pulls Note: - Requires reinforcing plate with an access plate and Torx screws for...
-
Jacknob Corp. 6251 3" High ADA Door Pull Brass-Chrome
6251 Door Pull 3" High (ADA) Brass/Chrome Polished Chrome Brass
-
General Partitions ADA Door Pull Kit (6300HC-SS)
(2) Door Pulls Thru-Bolted together through door Cast Stainless Steel
-
SafePath SafeShower™ Ramp Transitions
SafePathTM Products offers SafeShowerTM ramps and transitions for showers that require edge treatment or transitional elements for showers, walk-in showers/tubs and steam showers....
-
K5
K5. If the operating controls are set back 10 to 24 inches from the front edge of the counter or table are they no higher than 46 inches above the floor? [ADA Standards §...
-
4.27.3* Height
The highest operable part of controls, dispensers, receptacles, and other operable equipment shall be placed within at least one of the reach ranges specified in 4.2.5 and 4.2.6....
-
4.31.3* Mounting Height
The highest operable part of the telephone shall be within the reach ranges specified in 4.2.5 or 4.2.6.
-
4) Where the Standard is silent about changes in level
4) Where the Standard is silent about changes in level, such as 604.3 around a water closet or in a toilet compartment: Since there is no mention of the phrase "changes in level are not...
-
Scranton Toilet Partitions: Eclipse - Floor Mount Headrail
3D Rendering of Eclipse Toilet Partition
-
Figure 604.2 Water Closet Location – Drawing from the U.S. Access Board
-
11B-809.10.6.5 Thresholds
Where provided thresholds shall be 2 inches (51 mm) maximum in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units horizontal (26.6 degrees from the...
-
A4.17.3 Size and Arrangement
This section requires use of the 60 in (1525 mm) standard stall (Figure 30(a)) and permits the 36 in (915 mm) or 48 in (1220 mm) wide alternate stall (Figure 30(b)) only in...
-
Access Board: Shower Seats
This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
-
Access Board: Obstructed Side Reach
This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
-
4.17.3* Size and Arrangement
Standard toilet stalls with a minimum depth of 56 in (1420 mm) (see Fig. 30(a)) shall have wall-mounted water closets....
-
4.3 Reach Ranges
They specify maximum and minimum heights but do not take into consideration the fact that the depth and height of the obstruction can vary with a corresponding impact on the reach envelope...
-
Access Board: Multi User Toilet Room Layout
This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
-
Toilet Rooms-Special Exhibit Space
Toilet Rooms-Special Exhibit Space: u. The force required to push or pull open the restrooms' vestibule doors is 10 lbf, which exceeds the maximum allowable door opening force of...
-
H27
H27. Does this 36-inch wide stall have horizontal grab bars on both of the side partitions that are at least 36 inches long and 33 to 36 inches above the floor? [ADA Standards §...
-
C. Accessibility Within Toilet Rooms
C. Accessibility Within Toilet Rooms C1-a. Is there an area within the toilet room where a person who uses a wheelchair or mobility device can turn around - either a minimum...
-
11B-809.10.6.2 Slope
The slope of the shower floor shall be 1/2 inch (12.7 mm) per foot maximum in any direction and shall slope to a drain. The floor surfaces shall be of Carborundum, grit-faced tile or...
-
11B-809.10.6.6 Controls
Controls and operating mechanisms shall comply with Section 11B-309.4.
-
11B-809.10.6.7 Shower enclosures
Doors and panels of shower enclosures shall comply with Section 11B-809.10.5.4.
