218 Transportation Facilities
Search Results "Bus Rapid Transit"
-
218 Transportation Facilities
-
218.1 General
218.1 General. Transportation facilities shall comply with 218.
-
F. Chapter 5: Doorways, Circulation Paths, and Fare Collection Devices
Chapter 5 in the 2016 Non-Rail Vehicle Guidelines contains the technical requirements for doorways, illumination at doorways and boarding and alighting areas, passenger access...
-
11B-218 Transportation facilities.
[See subsections ...]
-
11B-218.1 General
Transportation facilities shall comply with Section 11B-218.
-
11B-218 Transportation facilities
[See subsections ...]
-
11B-218.1 General
Transportation facilities shall comply with Section 11B-218.
-
§ 38.95(c)(3) Ramp threshold
The transition from station platform to the ramp or bridge plate and the transition from car floor to the ramp or bridge plate may be vertical without edge treatment up to 1/4 inch....
-
R304.5.3 Cross Slope
The cross slope of curb ramps, blended transitions, and turning spaces shall be 2 percent maximum....
-
DEPARTMENT OF TRANSPORTATION DISABILITY LAW GUIDANCE: Origin-to-Destination Service
What are the obligations of transit providers to ensure that eligible passengers receive “origin-to-destination” service?...
-
Appendix E to Part 37—Reasonable Modification Requests
., providing fixed route bus service that people with disabilities can use to move among stops on the system, providing complementary paratransit service that gets eligible riders from their...
-
F245.2.3 Alterations and Additions
Where an entity is implementing a transition plan for program accessibility developed pursuant to regulations issued under section 504 of the Rehabilitation Act that designates specific...
-
Transportation
□ Always consider transportation to events or meetings. Hold meetings or events close to transportation routes whenever possible. If transportation is provided to all participants,...
-
T402.5 Surfaces
Ramp and bridgeplate surface material shall comply with T302 and extend across the full width and length of the ramp or bridgeplate.
-
§ 37.73 Purchase or lease of used non-rail vehicles by public entities operating fixed route systems
[See subsections ...]
-
§ 38.159(d)(4) Orientation
(4) Orientation. At least one securement device or system required by paragraph (a) of this section shall secure the wheelchair or mobility aid facing toward the front of the...
-
§ 38.159(c)(4) Ramp barriers
(4) Ramp barriers. Each side of the ramp shall have barriers at least 2 inches (50 mm) high to prevent mobility aid wheels from slipping off.
-
§ 38.161 Moveable aisle armrests
A minimum of 50% of aisle seats, including all moveable or removable seats at wheelchair or mobility aide securement locations, shall have an armrest on the aisle side which can...
-
§ 38.155 Interior circulation, handrails and stanchions
[See subsections ...]
-
B. Restrooms
B. Restrooms. The following is provided to assist manufacturers and designers to create restrooms which can be used by people with disabilities. These specifications are derived from...
-
§ 38.153(a)
(a) Floor surfaces on aisles, step treads and areas where wheelchair and mobility aid users are to be accommodated shall be slip-resistant.
-
§ 38.159(b)(9) Platform deflection
(9) Platform deflection. The lift platform (not including the entrance ramp) shall not deflect more than 3 degrees (exclusive of vehicle roll or pitch) in any direction between its...
-
§ 38.159(b)(3) Emergency operation
(3) Emergency operation. The lift shall incorporate an emergency method of deploying, lowering to ground level with a lift occupant, and raising and stowing the empty lift if the...
-
§ 38.159(b)(2) Controls
(2) Controls—