(a) This section applies to public and private entities....
Search Results "Cross Section"
-
§ 37.165(a)
-
11B-106.4 Interchangeability
See Chapter 2, Section 201.2....
-
Doors, Doorways, and Gates
Section 206.5 provides scoping requirements for doors, doorways, and gates....
-
C. Chapter 2: Scoping Requirements
Whereas nearly all scoping provisions for buses, OTRBs, and vans in the 2010 NPRM were “nested” as subsections to a single section (former T203), in the final rule, each discrete feature...
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
Residential dwelling units shall comply with Section 11B-233.3.4.2. 2....
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
Residential dwelling units shall comply with Section 11B-233.3.4.2. 2....
-
General
The 1991 Standards at sections 4.1.3(9); 4.1.6(1)(g); and 4.3.10 establish scoping and technical requirements for accessible means of egress....
-
806 Transient Lodging Guest Rooms
Section 806 addresses access to accessible guest rooms (806.2) and those guest rooms that provide access to persons who are deaf or hard of hearing (806.3)....
-
F203 General Exceptions
Section F203.2 establishes a general exception for elements complying with earlier standards issued pursuant to the ABA or to section 504 of the Rehabilitation Act of 1973....
-
Reach Ranges
The 2010 Standards, at section 308.3, lower that maximum height to 48 inches above the finish floor or ground....
-
FEDERAL LAWS
The definition of “special education” in section 602(29) of the IDEA includes instruction in physical education....
-
11B-504.8 Floor identification
Floor identification signs required by Chapter 10, Section 1023.9 complying with Sections 11B-703.1, 11B-703.2, 11B-703.3 and 11B-703.5 shall be located at the landing of each floor level...
-
11B-219.5 Permanent and portable systems
yes permanent system no outlets or wiring ETA Editor's Note The ADA requirements included at Section...
-
11B-504.8 Floor identification
Floor identification signs required by Chapter 10, Section 1023.9 complying with Sections 11B-703.1, 11B-703.2, 11B-703.3 and 11B-703.5 shall be located at the landing of each floor level...
-
11B-219.5 Permanent and portable systems
yes permanent system no outlets or wiring ETA Editor's Note The ADA requirements included at Section...
-
11B-1003.3.2 Boarding pier clearances
For example, at a launch ramp, if a 20 foot (6100 mm) long accessible boarding pier is provided, the entire 20 feet (6100 mm) must comply with the pier clearance requirements in Section...
-
11B-1003.3.2 Boarding pier clearances
For example, at a launch ramp, if a 20 foot (6100 mm) long accessible boarding pier is provided, the entire 20 feet (6100 mm) must comply with the pier clearance requirements in Section...
- Biodex BioStep® 2 Semi-Recumbent Elliptical Machine
- TotTurf® and Robertson Industries Poured Rubber Surfaces
-
General: ADA Standard Section 803.1
Section 903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
-
11B-306.3.1 General
Space under an element between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground shall be considered knee clearance and shall comply with Section 11B-306.3....
-
1017.3 Aisles in Groups B and M
In Group B and M occupancies, the minimum clear aisle width shall be determined by Section 1005.1 for the occupant load served, but shall not be less than 36 inches (914 mm)....
-
607 Bathtubs
Specifications for bathtubs in section 607 address clear floor space, seats, grab bars, operable parts, shower spray units, and enclosures....
-
§104.23(c)(1)
(1) Effective as of January 18, 1991, design, construction, or alteration of buildings in conformance with sections 3-8 of the Uniform Federal Accessibility Standards (UFAS) (Appendix A...